Skip to contentSkip to conversation

Nothing display in terminal with uboot 1.1.3 on 8347 board!

U-Boot-Users Simon Yang 2 participants 2 messages Nov 25, 2005

lore
Share & tools
lore

Simon Yang

author
#0 lore raw

Dear All,

After we program the HRCW and uboot.bin(1.1.3) into Flash and power on, nothing is shown in terminal, it seems that the UART doesn't initialize correctlly.
Our board information is as follow:
CPU:MPC8347E
Memory:256 DDR 333 DIMM
Flash:S29GL064MR2 8MB (8Mx8x1)

We program the HRCW into FF800000 and uboot.bin into FFF00000, and we also use Debugger check the values we programed, both Flash and Memory can be written when power on through the Debugger we find it really goes to the Address FFF00100 where the start of UBoot(start.S) to run the uboot image, but how can I trace the running process step by step? If no information display in terminal, whether it is caused by the wrong address set in configuration file or by the serial initialization?

Best Regards,

Simon

#1 lore raw
Quoted 4 lines · In message <[email protected]> you wrote:

After we program the HRCW and uboot.bin(1.1.3) into Flash and power on, nothing is shown in terminal, it seems that the UART doesn't initialize correctlly.

Well, then debug it...

Quoted 5 lines

We program the HRCW into FF800000 and uboot.bin into FFF00000, and we also use Debugger check the values we programed, both Flash and Memory can be written when power on through the Debugger we find it really goes to the Address FFF00100 where the start of UBoot(start.S) to run the uboot image, but how can I trace the running process step by step?

Use your debugger.

Quoted 3 lines

If no information display in terminal, whether it is caused by the wrong address set in configuration file or by the serial initialization?

Or by any other error in your port. You have a debugger attached, use it. That's what it was made for.

Best regards,

Wolfgang Denk

Signature · 5 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
... bacteriological warfare ... hard to believe we were once foolish
enough to play around with that.
	-- McCoy, "The Omega Glory", stardate unknown