Skip to contentSkip to conversation

problem with kernel 2.4.26 installation

DISCUSSION Slawomir Orlowski 2 participants 2 messages May 11, 2004 – May 12, 2004

lore
Share & tools
lore
#0 lore raw

Hello there,

I have got Dell server PowerEdge 2500 with dell installed RH 7.2 and 2.4.7-10 kernel (rpm installation).
I wanted to upgrade it to 2.4.26 from source.

So I have done like always:
make mrproper,
copied .config from 2.4.7 (did make menuconfig) make dep, clean, bzImage, modules, modules_install, install

and I got:
"
bsetup.s: Assembler messages:
bsetup.s:2503: Warning: indirect lcall without `*'
Root device is (8, 8)
Boot sector 512 bytes.
Setup is 4768 bytes.
System is 835 kB
+ '[' -x /root/bin/installkernel ']'
+ '[' -x /sbin/installkernel ']'
+ exec /sbin/installkernel 2.4.26 bzImage /usr/src/linux-2.4.26/System.map ''
/etc/lilo.conf: No such file or directory
make[1]: *** [install] Error 1
make: *** [install] Error 2
"
vmlinuz, System.map was created but intrid was not created and grub.conf was no upgraded I do not use lilo on this server, so why he wants to upgrade lilo ?.

I would really appreciate if somebody could help me how to proceed farther...
I'm really stuck.

Best regards
Slawomir Orlowski

#1 lore raw
Quoted 11 lines · you

Hello there,

I have got Dell server PowerEdge 2500 with dell installed RH 7.2 and 2.4.7-10 kernel (rpm installation).
I wanted to upgrade it to 2.4.26 from source.

So I have done like always:
make mrproper,
copied .config from 2.4.7 (did make menuconfig) make dep, clean, bzImage, modules, modules_install, install

Quoted 15 lines

and I got:
"
bsetup.s: Assembler messages:
bsetup.s:2503: Warning: indirect lcall without `*' Root device is (8, 8)
Boot sector 512 bytes.
Setup is 4768 bytes.
System is 835 kB
+ '[' -x /root/bin/installkernel ']'
+ '[' -x /sbin/installkernel ']'
+ exec /sbin/installkernel 2.4.26 bzImage /usr/src/linux-2.4.26/System.map '' /etc/lilo.conf: No such file or directory make[1]: *** [install] Error 1
make: *** [install] Error 2

As far as I can tell this problem is related to your "/sbin/installkernel" script... it finds LILO and so calls it, but the lilo configuration file doesn't exist ;-)!

I think that "/sbin/installkernel" is doing the right thing (from its point of view)...

Shortly: REMOVE LILO, if you don't use it why is it installed?

Another thing you can do is to change "/sbin/installkernel" to never call LILO.

Bye

Signature · 2 lines
	Paolo Ornati
	Linux v2.6.6