ide-scsi burning broken
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 15 lines · Willem Riede
Quoted 12 lines · Markus Hästbacka
Hi list,
I was going to burn a cd earlier today, and I noticed it wont work in 2.6.3-rc1, k3b (the burning software) just freezed in 'D' state, and after a moment I got something like this in my dmesg:
/dec/sr0 drive not ready!
/dec/sr0 drive not ready!
/dec/sr0 drive not ready!
[x1000]
So I guess the ide-scsi patches broke up things.The burning in 2.6.1-mm4 works fine.
Quoted 7 lines
Quoted 2 lines
I know I should use ide-cd whatever, but I've always done it with ide-scsi and I wont easily change that.
I doubt that changes in ide-scsi caused this, you just ran out of luck :-( Since you're not supposed to use ide-scsi for cd writing (as you admit knowing), nobody is going to help you with this problem...
I think CD burning is like the canary in the coal mine, if it stops working something is broken. It may be "better" to burn with ide-cd, in some hope of avoiding overhead which is small beyond measurement for data CDs on most systems, but it should work, and the fact that it has stopped working probably indicates something has changed which will later rise up to bite us with IDE tape, or MO, or avoiding ide-floppy for ZIP, or whatever.
If you think of it as a test program for the interface it matches reality better, except that many people cross boot between 2.4 and 2.5, don't want to build using Joreg's odd idea of header files, and generally use this interface for production use.
Signature · 1 line
bill davidsen, TMR