Skip to contentSkip to conversation

XFree86 4.0 Compiles, doesn't run

DISCUSSION William H. Schultz 1 participant 1 message Mar 17, 2000 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Hello all.

I've recently downloaded and compiled the xfree86 4.0 source, as I have a dual monitor setup and would love to get it running under Linux. The card I primarily use is a Voodoo3 2000. Xpmac from 4.0 will run--I get the gray screen with the X mouse when I run it by hand, however, none of the scripts will boot into a useable interface.

I ran the stuff just like the instructions said: make
World... make install... make install.man...

This very clearly installs the software, but I can't get a useable X interface.

Any ideas? Anyone have it working?

Hank

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/