Frustration with MACE...
I've spent several hours tonite trying to get the MACE driver to behave properly on a 7200/90 with the 2.2.15pre20 kernel.
The internal ethernet is connected via the 10BT port. It works sometimes for a while and then just stops working. I have tried it through a switch and with a cisco 675.
I looked over the plscc configs, noticed the little force AAUI config. Tried different plscc combos, tried different phycc (PHY) combos, it's still flakey! I've tried it on 3 7200's. It works pretty well on only one.
If the machine is in MacOS I can pump megabytes through the Mesh without trouble.
If I use a PCI ethernet card, it works perfectly. I'm running out of ideas (and if don't get this working, I'll be out of PCI slots).
When it doesn't work, I don't even get errors in netstat -in.
Any IDEAS????
Bob
--
Robert E. Brose II N0QBJ
http://www.jriver.com/~bob/
[email protected]
** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/