Error after make bzImage
Hello!
I am trying to recompile my kernel after adding
some patches... After making the changes, I first run make dep and then make clean...both run fine. However, after running make bzImage it gives me the following errors:
make[2]: *** [ksyms.o] Error 1
make[2]: Leaving directory
`/usr/src/linux-2.2.16/kernel'
make[1]: *** [first_rule] Error 2
make[1]: Leaving directory
`/usr/src/linux-2.2.16/kernel'
make: *** [_dir_kernel] Error 2
I was not able to figure out what may be causing this problem. Can some one please help me out with this one?
Thank you very much
Kaustubh
__________________________________________________
Do You Yahoo!?
Yahoo! Shopping - Thousands of Stores. Millions of Products.
http://shopping.yahoo.com/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
Quoted 17 lines · Kaustubh Phanse
Hello!
I am trying to recompile my kernel after adding
some patches... After making the changes, I first run make dep and then make clean...both run fine. However, after running make bzImage it gives me the following errors:make[2]: *** [ksyms.o] Error 1
make[2]: Leaving directory
`/usr/src/linux-2.2.16/kernel'
make[1]: *** [first_rule] Error 2
make[1]: Leaving directory
`/usr/src/linux-2.2.16/kernel'
make: *** [_dir_kernel] Error 2
Quoted 3 lines
I was not able to figure out what may be causing this problem. Can some one please help me out with this one?
Try:
cd /usr/src/linux/whatever
cp .config .. # Save your configuration
make distclean # Get rid of all old junk
cp ../.config . # Restore
make oldconfig
make dep
make bzImage
make modules
...etc
Cheers,
Dick Johnson
Penguin : Linux version 2.4.0 on an i686 machine (799.54 BogoMips).
"Memory is like gasoline. You use it up when you are running. Of course you get it all back when you reboot..."; Actual explanation obtained from the Micro$oft help desk.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/