iopener reboot
Hi,
I've gone and tried the ultimate acid test of crappy x86 hardware on the vanilla prerelease kernel, and installed it on my iopener. The kernel loads, uncompresses, initializes hardware, and then immediately reboots.
It all happens so fast that I do not really get a chance to see the last thing printed before it fails.
The last kernel that I had running on this was a test12 pre something.
Any ideas?
--Matt Galgoci
Signature · 5 lines
"Hey Y'all, Watch this!" --Mike Wangsmo - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] Please read the FAQ at http://www.tux.org/lkml/
Quoted 6 lines · Matthew Galgoci
Hi,
I've gone and tried the ultimate acid test of crappy x86 hardware on the vanilla prerelease kernel, and installed it on my iopener. The kernel loads, uncompresses, initializes hardware, and then immediately reboots.
Quoted 9 lines
It all happens so fast that I do not really get a chance to see the last thing printed before it fails.
The last kernel that I had running on this was a test12 pre something.
Any ideas?
--Matt Galgoci
Recompile as 'generic' as you can get. Pretend you have a '486. Use a known good 'C' compiler even though it may not be 'optimum'. Once this boots okay, try compiling for a Pentium '586' etc. You may have found some problem with CPU identification.
A quick hack at the possibility of a BIOS reporting the wrong amount of memory is to put append="mem=16m" in your LILO config just to pretend that you only have 16 megabytes of RAM. Assuming you have more than 16 megabytes, if the machine boots, you have isolated the problem to bad BIOS reporting.
Step-by-step, using these kinds of tricks, you should be able to find the problem.
Cheers,
Dick Johnson
Penguin : Linux version 2.4.0 on an i686 machine (799.54 BogoMips).
"Memory is like gasoline. You use it up when you are running. Of course you get it all back when you reboot..."; Actual explanation obtained from the Micro$oft help desk.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/