possible bug with adaptec aic-7896 and 2.4.x
in 2.4.0 and 2.4.1 on a pentium 3 with an onboard adaptec AIC-7896, i receive the following after it is detected:
scsi: aborting command due to timeout: pid 0, scsi0, channel 0, id 0 lun 0 Inquiry 00 00 00 ff 00
i get the error twice, then the box hangs. this occurs on both a single processor box and a dual processor box with a kernel without SMP support. on a dual processor box when SMP is compiled in, i receive a similar error:
scsi: aborting command due to timeout: pid 0, scsi0, channel 0, id 1 lun 1 Inquiry 20 00 00 ff 00
but the box continues to boot fine.
the same hardware configuration in 2.2.15 works fine, and a similar hardware configuration using a AIC-7895 instead of a AIC-7896 running 2.4.x works fine.
any ideas?
thanks,
a
Signature · 6 lines
andrew prins (linux & diet coke advocate) finger [email protected] for pgp key. - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] Please read the FAQ at http://www.tux.org/lkml/