IDE-TAPE (Onstream DI-30) problems 2.4.*
Hi folks:
Since upgrading to 2.4.* from 2.2.18 (with ide-patches to support my Onstream DI30) I've seen some wierd behavior. When I back up my filesystem to tape using tar, it seems to interfere with the network, or something. In particular, I run vncserver on the host and connect via vncviewer from another host. Shortly after I start the tape backup, the vncviewer closes. I can reconnect to it but shortly after, it will close again. The vncserver process continues to run. I can always reconnect to it but the connection will be terminated after a short period of time. When the tape backup stops, vnc returns to normal. I haven't observed
the problem with any applications than vnc (yet). There are no messages
in the syslog to indicate anything abnormal is occurring.
Here's what I see at boot-up:
Feb 25 22:39:08 camera1 kernel: ide-tape: hdc <-> ht0: OnStream DI-30 rev 1.06 Feb 25 22:39:08 camera1 kernel: ide-tape: hdc <-> ht0: 990KBps, 64*32kB buffer, 10208kB pipeline, 60ms tDSC, DMA
-----------------------------------------------------------------------------
David Konerding
Email: [email protected]
WWW: http://picasso.nmr.ucsf.edu/~dek
PGP: http://picasso.nmr.ucsf.edu/~dek/content_pgp.html
-----------------------------------------------------------------------------