Linux 2.4.2-ac12
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 26 lines · Linus Torvalds
In article <Pine.LNX.4.32.0103052121180.1029-100000@nic-31-c31-100.mn.mediaone.net>,
Quoted 9 lines · Scott M. Hoffman
It may not be related, but out of five boot attempts, only one got past the IDE driver stage(ie, below from 2.4.2 :
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 16
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c596b (rev 23) IDE UDMA66 controller on pci00:07.1Quoted 4 lines
ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:DMA, hdd:DMA)I've had 2.4.2 running great for the past 10 days. Need any more info?
I'd love to hear anything you can come up with. What's the next step in your boot process, ie what's the part that normally shows up but doesn't with 2.4.2-ac12? Is this using IDE-SCSI, for example?
One thing that both 2.4.3-pre3 and -ac12 do is to not have allocate a result buffer for
TEST_UNIT_READY. I don't see why that should matter, but can you try un-doing the patch to "scsi_error.c" and see if that makes a difference. I'm worried about this report, and the buslogic corruption thing..
Quoted 7 lines
Justin: there's another "2.4.3-pre2 corrupts all disks on a buslogic controller" report. The interesting part is that 2.4.3-pre2 doesn't actually contain any buslogic changes. The only generic-scsi changes were yours. Ideas?
Linus
Just trying 2.4.3-pre2 now. It appears to be working fine. I used the
same config from my ac11-12 attempts. My systems problem with ac11-12 must not be something common between them. Hope this helps.
Scott
Quoted 3 lines
Just trying 2.4.3-pre2 now. It appears to be working fine. I used the
same config from my ac11-12 attempts. My systems problem with ac11-12 must not be something common between them. Hope this helps.
It helps a lot. I now know not to submit the VIA ide driver to Linus until further investigation is completed.
Quoted 6 lines · Alan Cox
Quoted 3 lines
Just trying 2.4.3-pre2 now. It appears to be working fine. I used the
same config from my ac11-12 attempts. My systems problem with ac11-12 must not be something common between them. Hope this helps.It helps a lot. I now know not to submit the VIA ide driver to Linus until further investigation is completed.
Now you know why I pawned it off the VIA-core to Vojtech ;-) It is a mess!
Andre Hedrick
Linux ATA Development