IDE bug in 2.4.2-ac12?
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 5 lines · Vojtech Pavlik
Quoted 4 lines · Konrad Stopsack
Quoted 3 lines · Vojtech Pavlik
Quoted 1 line · Konrad Stopsack
Quoted 1 line
I don't see any other way how the ZIP could have impact on the
IDE
Quoted 10 lines
Quoted 4 lines
HDD
Quoted 2 lines
Quoted 2 lines
Quoted 1 line
on a different IDE interface.
The 82c586b can be a chip with locked-together IDE controllers,
can't
Quoted 5 lines
Quoted 3 lines
it?
What do you mean by 'locked together'?
Nasty chips whose two IDE channels aren't really separated. On one IDE channel you either can use DMA or not. On these chips, switching off
DMA
Quoted 10 lines
Quoted 2 lines
at the second controller also disables DMA at the first.
Then this is not the case of the 586b. All four IDE drive transfer speeds are programmed separately.
Quoted 4 lines
Quoted 3 lines
I have two vt82c586b's here and one old vt82c586. All work fine with different drive combinations, one even has a CD-ROM and a ZIP on the secondary channel like yours.
Quoted 8 lines
Quoted 3 lines
Yeah, Ok. My combination SHOULD work without any problems...
What else could I do? Swap CD-ROM and ZIP? Try new 2.4.2-ac14 with
command
Quoted 1 line
line parameters "ide0=dma ide1=nodma"?
I don't know. I'm attaching the very latest driver - but I doubt it changes anything.
Thank you. I'll try the 2.4.2-ac14 kernel and your driver.
cu Konrad
Signature · 3 lines
Konrad Stopsack - [email protected] Sent through GMX FreeMail - http://www.gmx.net