Skip to contentSkip to conversation

2.4 and PPPoE problem

DISCUSSION Martin Hicks 2 participants 3 messages Mar 12, 2001

lore
Share & tools
lore
#0 lore raw

Hello,

I'm using PPPoE with an i586 machine running 2.4.2.

The machine connects fine and allows network traffic to pass through the link.

However, certain websites seem to choke.
(notable ones are www.chapters.ca and www.hp.com)

Using Lynx or Netscape I get the same results, a few bytes of traffic are received and then nothing (eventually the connection times out).

The same does not happen in windows. (ugh)

I have not encountered any machine that I have telnet/ftp/ssh access to that breaks in this way so I can only confirm that http traffic is not working.

This gateway machine does masquerading, and internal machines and the external machine react the same way.

TIA
mh

Here is some useful info:

mort@galileo:~$ uname -a
Linux galileo 2.4.2 #4 Thu Feb 22 14:13:23 EST 2001 i586 unknown
mort@galileo:~$ /sbin/ifconfig ppp0
ppp0      Link encap:Point-to-Point Protocol  
          inet addr:209.217.122.37  P-t-P:209.217.122.1  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1480  Metric:1
          RX packets:1272056 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1476697 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3 
          RX bytes:430171737 (410.2 Mb)  TX bytes:1260803415 (1202.3 Mb)
mort@galileo:~$ /sbin/route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
magma           *               255.255.255.255 UH    0      0        0 ppp0
192.168.69.0    *               255.255.255.0   U     0      0        0 eth0
default         magma           0.0.0.0         UG    0      0        0 ppp0
Signature · 3 lines
Martin Hicks   || [email protected]    
Use PGP/GnuPG  || DSS PGP Key: 0x4C7F2BEE  
Beer: So much more than just a breakfast drink.
#1 lore raw
Quoted 3 lines · Martin Hicks

Hello,

I'm using PPPoE with an i586 machine running 2.4.2.

are you using the kernel pppoe or the user-space one (rp-pppoe, etc)? did it work on other kernels?

Quoted 12 lines

The machine connects fine and allows network traffic to pass through the link.

However, certain websites seem to choke.
(notable ones are www.chapters.ca and www.hp.com)

Using Lynx or Netscape I get the same results, a few bytes of traffic are received and then nothing (eventually the connection times out).

Quoted 8 lines

The same does not happen in windows. (ugh)

I have not encountered any machine that I have telnet/ftp/ssh access to that breaks in this way so I can only confirm that http traffic is not working.

This gateway machine does masquerading, and internal machines and the external machine react the same way.

are you positive the external (2.4.2 machine, right?) acts this way?

you can send me a tcpdump trace of a session or two that chokes.

Quoted 33 lines

TIA
mh

Here is some useful info:

mort@galileo:~$ uname -a
Linux galileo 2.4.2 #4 Thu Feb 22 14:13:23 EST 2001 i586 unknown
mort@galileo:~$ /sbin/ifconfig ppp0
ppp0      Link encap:Point-to-Point Protocol
          inet addr:209.217.122.37  P-t-P:209.217.122.1  Mask:255.255.255.255
          UP POINTOPOINT RUNNING NOARP MULTICAST  MTU:1480  Metric:1
          RX packets:1272056 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1476697 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:3
          RX bytes:430171737 (410.2 Mb)  TX bytes:1260803415 (1202.3 Mb)
mort@galileo:~$ /sbin/route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
magma           *               255.255.255.255 UH    0      0        0 ppp0
192.168.69.0    *               255.255.255.0   U     0      0        0 eth0
default         magma           0.0.0.0         UG    0      0        0 ppp0

--

Martin Hicks   || [email protected]
Use PGP/GnuPG  || DSS PGP Key: 0x4C7F2BEE

Beer: So much more than just a breakfast drink.

------------------------------------------------------------------------
Part 1.2Type: application/pgp-signature

#2 lore raw
In reply to Martin Hicks

Yes...my MTU on ppp0 was to high. Thanks.

mh

Quoted 30 lines · mulix

hi,

you might want to check your mtu and mru values on both the external interface (i assume you are using an ADSL modem, from your usage of PPPoE, so that will be eth0) and the internal interface (ppp0). the mtu and mru values on the internal interface should be a bit less than those on the external interface, to work around modem bugs.

here in israel, an MTU value of 1500 for the external interface and 1452 for the internal (1452) seems to work fine and solve a problem which sounds exactly like yours.

Quoted 9 lines · Martin Hicks

The machine connects fine and allows network traffic to pass through the link.

However, certain websites seem to choke.
(notable ones are www.chapters.ca and www.hp.com)

Using Lynx or Netscape I get the same results, a few bytes of traffic are received and then nothing (eventually the connection times out).

Signature · 4 lines
mulix
http://www.advogato.com/person/mulix

linux/reboot.h: #define LINUX_REBOOT_MAGIC1 0xfee1dead
Signature · 3 lines
Martin Hicks   || [email protected]    
Use PGP/GnuPG  || DSS PGP Key: 0x4C7F2BEE  
Beer: So much more than just a breakfast drink.