Stuck: What to do with solid locks?
Quoted 3 lines · you
Oh, I realize this. I don't mind and even expect the occational crash right now in the 2.4.x series, but the frequency of these crashes fall
Well, you say this, but
...more whinny post deleted...
Quoted 1 line
to begin to help fix this problem (or these problems).
Twice your tone plays different from your words. A scan of lkml should have shown you that your problem is not a major problem, it's far more likely to be unique than general.
- -------------------------------------------------------
1) try a different distribution, RH is bleeding edge at times and the problems may not be entirely within the kernel. For example, Slackware-current is a base (without any additions it runs a 2.4 kernel) I've used with 4 machines now, and the only problem was the loopback fs hang of a month ago.
2) remove drivers & hardware goodies to see if stability improves. change your typical application load to see what happens. I actually do this the other way, run a simple kernel and then add to it.
3) there are a lot of 2.4 kernels, over 40 variants, look thru the ChangeLogs, maybe your hardware is mentioned someplace. try them to see if stability improves.
In short, try the reduce the possible areas for a bug, ideally getting to a point where you can state : 2.4.X-Y with AAA locks while 2.4.X-Y without AAA does not lock. That will bring more attention.
oh, and
4) boot into your last working kernel when you want to accomplish something.