tulip driver BROKEN in 2.4.5-pre4
Quoted 8 lines
Could you post the output of
#tulip-diag -mm -aa -f
with the broken driver?
Some code that's required for Linksys Tulip clones was moved from pnic specific part into the generic part, perhaps that causes problems.
Here is the output from the kernels I've tested to try to get the driver working:
2.4.4-ac6, this kernel works!
tulip-diag.c:v2.06 1/8/2001 Donald Becker ([email protected])
http://www.scyld.com/diag/index.html
Index #1: Found a Digital DC21041 Tulip adapter at 0xd800. Digital DC21041 Tulip chip registers at 0xd800:
0x00: ffe08000 ffffffff ffffffff 0129f000 0129f200 fc660000 fffe2002
ffffebef
0x40: fffe0000 ffff03ff ffffffff fffe0000 000001c8 ffffef05 ffffff3fffff0008
Port selection is half-duplex.
Transmit started, Receive started, half-duplex.
The Rx process state is 'Waiting for packets'.
The Tx process state is 'Idle'.
The transmit unit is set to store-and-forward.
The NWay status register is 000001c8.
No MII transceivers found!
Internal autonegotiation state is 'Autonegotiation disabled'.
--------------------------------------------------------------
2.4.5-pre4 this kernel doesn't work
tulip-diag.c:v2.06 1/8/2001 Donald Becker ([email protected])
http://www.scyld.com/diag/index.html
Index #1: Found a Digital DC21041 Tulip adapter at 0xd800. Digital DC21041 Tulip chip registers at 0xd800:
0x00: ffe08000 ffffffff ffffffff 0129e000 0129e200 fc660000 fffe2202
ffffebef
0x40: fffe0000 ffff03ff ffffffff fffe0000 000050c8 ffffef01 ffffffffffff0008
Port selection is full-duplex.
Transmit started, Receive started, full-duplex.
The Rx process state is 'Waiting for packets'.
The Tx process state is 'Idle'.
The transmit unit is set to store-and-forward.
The NWay status register is 000050c8.
No MII transceivers found!
Internal autonegotiation state is 'Negotiation complete'.
--------------------------------------------------------------
2.4.4-ac9 with tulip 1.1.7 driver (from sf.net/projects/tulip)
tulip-diag.c:v2.06 1/8/2001 Donald Becker ([email protected])
http://www.scyld.com/diag/index.html
Index #1: Found a Digital DC21041 Tulip adapter at 0xd800. Digital DC21041 Tulip chip registers at 0xd800:
0x00: ffe08000 ffffffff ffffffff 0129f000 0129f200 fc660000 fffe2202
ffffebef
0x40: fffe0000 ffff03ff ffffffff fffe0000 000050c8 ffffef01 ffffffffffff0008
Port selection is full-duplex.
Transmit started, Receive started, full-duplex.
The Rx process state is 'Waiting for packets'.
The Tx process state is 'Idle'.
The transmit unit is set to store-and-forward.
The NWay status register is 000050c8.
No MII transceivers found!
Internal autonegotiation state is 'Negotiation complete'.
Let me know if I can provide any more useful information about the
driver problem.
John
----------------
[email protected]