Skip to contentSkip to conversation

aic7xxx problem on -ac series

DISCUSSION Costas Tavernarakis 2 participants 3 messages May 24, 2001

lore
Share & tools
lore
#0 lore raw

Hi all,

I'm not subscribed to LKML, so please Cc: me with any replies.

I'm running 2.4.5-pre4 with success on an ASUS-CUV4X-D based system (noapic boot parameter, highmem). This kernel works for me (with a few occasional hard lockups, but that's another story).

However, I'm having trouble with kernels from the -ac series. These kernels (with noapic) halt while detecting the first scsi controller on the system. The messages I get are:

SCSI subsystem driver Revision: 1.00
PCI: Found IRQ9 for device 00:09.0
PCI: The same IRQ used for device 00:0a.1
ahc_pci: 0:90: Using left over BIOS settings

and then the system stops responding.

while -pre4 goes ahead to print:

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.13

        <Adaptec 29160N Ultra160 SCSI adapter>
        aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/255 SCBs

...

The same problem is seen with virtually all kernels in 2.4.4-ac series, including -ac15. (haven't tried any earlier -ac, though).

lspci on this system gives:

00:00.0 Host bridge: VIA Technologies, Inc. VT82C693A/694x [Apollo PRO133x] (rev c4) 00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598/694x [Apollo MVP3/Pro133x AGP] 00:04.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40) 00:04.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) 00:04.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16) 00:04.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16) 00:04.4 Host bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40) 00:09.0 SCSI storage controller: Adaptec 7892A (rev 02)
00:0a.0 SCSI storage controller: Symbios Logic Inc. (formerly NCR) 53c875 (rev 14) 00:0a.1 SCSI storage controller: Symbios Logic Inc. (formerly NCR) 53c875 (rev 14) 00:0b.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74) 00:0c.0 Multimedia audio controller: Creative Labs SB Live! EMU10000 (rev 08) 00:0c.1 Input device controller: Creative Labs SB Live! (rev 08) 01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400 AGP (rev 82)

ver_linux output:
Linux idefix 2.4.5-pre4 #4 SMP Mon May 21 14:52:36 EEST 2001 i686 unknown

Gnu C                  2.95.4
Gnu make               3.79.1
binutils               2.11.90.0.7
util-linux             2.11b
mount                  2.11b
modutils               2.4.6
e2fsprogs              1.19
reiserfsprogs          3.x.0j
Linux C Library        2.2.3
Dynamic linker (ldd)   2.2.3
Procps                 2.0.7
Net-tools              1.60
Console-tools          0.2.3
Sh-utils               2.0.11

Modules Loaded

I am, of course, willing to provide any more information you may find important and/or to test any patches.
I'm not a kernel expert, though...

#1 lore raw

I have also seen this problem... I don't have any ideas. Is this a module or compiled in?

Later, JOSH

Quoted 76 lines · Costas Tavernarakis

Hi all,

I'm not subscribed to LKML, so please Cc: me with any replies.

I'm running 2.4.5-pre4 with success on an ASUS-CUV4X-D based system (noapic boot parameter, highmem). This kernel works for me (with a few occasional hard lockups, but that's another story).

However, I'm having trouble with kernels from the -ac series. These kernels (with noapic) halt while detecting the first scsi controller on the system. The messages I get are:

SCSI subsystem driver Revision: 1.00
PCI: Found IRQ9 for device 00:09.0
PCI: The same IRQ used for device 00:0a.1
ahc_pci: 0:90: Using left over BIOS settings

and then the system stops responding.

while -pre4 goes ahead to print:

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.1.13

        <Adaptec 29160N Ultra160 SCSI adapter>
        aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/255 SCBs

...

The same problem is seen with virtually all kernels in 2.4.4-ac series, including -ac15. (haven't tried any earlier -ac, though).

lspci on this system gives:

00:00.0 Host bridge: VIA Technologies, Inc. VT82C693A/694x [Apollo PRO133x] (rev c4) 00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598/694x [Apollo MVP3/Pro133x AGP] 00:04.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40) 00:04.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) 00:04.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16) 00:04.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16) 00:04.4 Host bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40) 00:09.0 SCSI storage controller: Adaptec 7892A (rev 02)
00:0a.0 SCSI storage controller: Symbios Logic Inc. (formerly NCR) 53c875 (rev 14) 00:0a.1 SCSI storage controller: Symbios Logic Inc. (formerly NCR) 53c875 (rev 14) 00:0b.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 74) 00:0c.0 Multimedia audio controller: Creative Labs SB Live! EMU10000 (rev 08) 00:0c.1 Input device controller: Creative Labs SB Live! (rev 08) 01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400 AGP (rev 82)

ver_linux output:
Linux idefix 2.4.5-pre4 #4 SMP Mon May 21 14:52:36 EEST 2001 i686 unknown

Gnu C                  2.95.4
Gnu make               3.79.1
binutils               2.11.90.0.7
util-linux             2.11b
mount                  2.11b
modutils               2.4.6
e2fsprogs              1.19
reiserfsprogs          3.x.0j
Linux C Library        2.2.3
Dynamic linker (ldd)   2.2.3
Procps                 2.0.7
Net-tools              1.60
Console-tools          0.2.3
Sh-utils               2.0.11

Modules Loaded

I am, of course, willing to provide any more information you may find important and/or to test any patches.
I'm not a kernel expert, though...

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

#2 lore raw
In reply to Costas Tavernarakis
Quoted 4 lines · Josh Logan

I have also seen this problem... I don't have any ideas. Is this a module or compiled in?

Compiled in. It connects the boot disk.

Maybe it's not an aic7xxx problem but a pci one, since 2.4.5-pre uses the same version of the driver.