Skip to contentSkip to conversation

Install CD causes reboot on 712/80

parisc-linux James FitzGibbon 1 participant 2 messages May 26, 2001 1 message not in the archive

lore
Share & tools
lore
#0 lore raw

I'm new to PARISC-Linux. I've had a 712/80 sitting around for a few years and thought I'd give it a go. Using the palinux-0.6.1-32STI.iso image, I burned a CD and attempted to install.

The boot process in and of itself went fine. The kernel came up, reported all of the devices that are shown for this model in the hardware database. After init entered runlevel 2, the message "Setting up /tmp and /var/log ramdisks" was displayed. About 5 seconds after that, the system rebooted.

I've tried futzing around with the SCSI ids with no luck. Does anyone have an idea or procedure I can try to get around this or find out more information as to why it's happening?

I'm going to try the 0.6 image as well as the serial console one in the meantime (I have firmware 2.3, so I should be OK to go back and forth).

Thanks.

Signature · 1 line
j.
#2 lore raw
In reply to a message not in the archive
Quoted 3 lines · * Jonathan Crockett ([email protected]) [010526 10:04]:

I have a 715/80 with both the on board graphic and a expansion graphic card, that had very similar symptoms. I disconnected the addon graphics card and the STI image then worked. Hope that gives you some insight...

Using the 0.6 serial image worked for me (the 0.61 image died the same as the STI). I did try removing what is the only addon card in the box, but it looks more like cache than video. It didn't help the 0.61 image.

The output regarding ramdisks is different on 0.6:

INIT: Entering runlevel: 2
Setting up /tmp ramdisk4096+0 records in
4096+0 records out

Then it gives me the login prompt. On 0.61, it would go:

INIT: Entering runlevel: 2
Setting up /tmp and /var/log ramdisks

and reboot. So something is different regarding ramdisks (or perhaps mkfs) on 0.61 vs 0.60.

Thanks for the help.

Signature · 1 line
j.