2.4.5-ac3: qlogic corruption on alpha
i narrowed down some corruption i was having. it only happens on drives attached to my qlogic isp card. 2.2 has no problem, and in 2.4.5-ac3 my sym53c875 works fine. this machine is an alpha miata. it only happens when writing out a lot to disk. eg, untarring a kernel tarball, restoring a backup. anyone else see this?
Signature · 2 lines
Tom Vier <[email protected]> DSA Key id 0x27371A2C
Quoted 5 lines · Tom Vier
i narrowed down some corruption i was having. it only happens on drives attached to my qlogic isp card. 2.2 has no problem, and in 2.4.5-ac3 my sym53c875 works fine. this machine is an alpha miata. it only happens when writing out a lot to disk. eg, untarring a kernel tarball, restoring a backup. anyone else see this?
Is this reproducible?
A patch went into ac3 which attempts to address qlogicisp problems on Alpha. It originated from the nether regions deep inside Compaq, original source unknown. There is a -extraordinarily slight- possibility this patch (which simply adds "mb()") causes problems. However, it is more likely that the patch is harmless but also useless, not fixing the real problem.
Other questions - is your machine SMP? How much RAM?
Signature · 3 lines
Jeff Garzik | Disbelief, that's why you fail. Building 1024 | MandrakeSoft |
Quoted 6 lines · Tom Vier
i narrowed down some corruption i was having. it only happens on drives attached to my qlogic isp card. 2.2 has no problem, and in 2.4.5-ac3 my sym53c875 works fine. this machine is an alpha miata. it only happens when writing out a lot to disk. eg, untarring a kernel tarball, restoring a backup. anyone else see this?
Also, what compiler are you using? Depending on your current compiler, switching to another compiler according to one of the following permutations would be very instructive for us debugging the problem, at least.
gcc-2.96-RH -> gcc-2.95.3 gcc-2.95.2 -> gcc-2.95.3 gcc-2.95.3 -> egcs-1.1.2
Regards,
Jeff
Signature · 3 lines
Jeff Garzik | Disbelief, that's why you fail. Building 1024 | MandrakeSoft |
Quoted 8 lines · Jeff Garzik
Quoted 5 lines · Tom Vier
i narrowed down some corruption i was having. it only happens on drives attached to my qlogic isp card. 2.2 has no problem, and in 2.4.5-ac3 my sym53c875 works fine. this machine is an alpha miata. it only happens when writing out a lot to disk. eg, untarring a kernel tarball, restoring a backup. anyone else see this?
Is this reproducible?
yes. by restoring a backup from tape. i tried cat /dev/zero > /dev/sdb1, but that wasn't enough to trigger any corruption (i correctly wrote all zeros). actually, now that i think about it, a good chunk of /dev/sdb2 was cached when i read it back, so that wasn't a very good test. i definetly get corruption under 2.4.5-ac4.
<snip>
Quoted 1 line
Other questions - is your machine SMP? How much RAM?
UP, half gig.
Signature · 2 lines
Tom Vier <[email protected]> DSA Key id 0x27371A2C
Quoted 4 lines · Jeff Garzik
Also, what compiler are you using? Depending on your current compiler, switching to another compiler according to one of the following permutations would be very instructive for us debugging the problem, at least.
debian 2.25.2 20000220
Quoted 3 lines
gcc-2.96-RH -> gcc-2.95.3 gcc-2.95.2 -> gcc-2.95.3 gcc-2.95.3 -> egcs-1.1.2
i'll give another one a try, tomorrow.
Signature · 2 lines
Tom Vier <[email protected]> DSA Key id 0x27371A2C