Skip to contentSkip to conversation

PCI (?) problems of MSI K7T266 Pro = MS-6380 / VIA KT266 8233

DISCUSSION Stanislav Brabec 2 participants 3 messages Sep 5, 2001 – Sep 7, 2001

lore
Share & tools
lore
#0 lore raw

Hallo,

I have Microstar mainboard MSI K7T266 Pro (MS-6380) with VIA KT266 chipset (VIA 8233), Athlon 1200/266, linux-2.4.9

Does anybody with this mainboard have some problems (or using it succesfull), or should I suspect some bad setup / problematic PCI card or more particular bugs?

Thanks for any info (please reply to my e-mail address)

I have encountered many, probably PCI related problems:

- USB PC2PC driver sometimes looses data errors (cca once per 20MB)
- SCSI scanner sometimes hangs scanning
- SCSI CD-ROM/writer sometimes fails to mount CD-ROM (read errors)
- Mangled sound output from AC97 codec
- PCI bus cannot be overclocked to more than 34.5 MHz

Used patches:
defined VIA_NEW_BRIDGES_TESTED uncommented in drivers/ide/via82cxxx.c ftp://ftp.suse.com/pub/people/garloff/linux/dc395/ (driver for SCSI DC315U) ftp://ftp.penguin.cz/pub/users/utx/linux-kernel/ (driver for USB PC2PC cable)

Compiler: gcc-2.95.3 & gcc-3.0.1

I have tried to activate all PCI quirks and special inits from older chipsets without any success.

I cannot test my machine with other OS.

00:00.0 Host bridge: VIA Technologies, Inc. VT8367 [KT266]
00:01.0 PCI bridge: VIA Technologies, Inc. VT8367 [KT266 AGP]
00:07.0 VGA compatible controller: Tseng Labs Inc ET6000 (rev 70)
00:08.0 SCSI storage controller: Tekram Technology Co.,Ltd. TRM-S1040 (rev 01) 00:11.0 ISA bridge: VIA Technologies, Inc. VT8233 PCI to ISA Bridge
00:11.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) 00:11.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 18)
00:11.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 18)
00:11.4 USB Controller: VIA Technologies, Inc. UHCI USB (rev 18)
00:11.5 Multimedia audio controller: VIA Technologies, Inc. AC97 Audio Controller (rev 10)

Signature · 1 line
Stanislav Brabec
#1 lore raw
Quoted 6 lines

I have Microstar mainboard MSI K7T266 Pro (MS-6380) with VIA KT266 chipset (VIA 8233), Athlon 1200/266, linux-2.4.9

Does anybody with this mainboard have some problems (or using it succesfull), or should I suspect some bad setup / problematic PCI card or more particular bugs?

We have a machine with this motherboard and a 1.4Ghz Athlon CPU and use it without significant problems.

Quoted 1 line

I have encountered many, probably PCI related problems:

I don't find any of these to point toward PCI problems, are there other reasons you would suspect PCI?

Quoted 1 line

- USB PC2PC driver sometimes looses data errors (cca once per 20MB)

This actually sounds pretty good, do you really mean one error per 20MB? I've never used the PC2PC driver but knowing the nature of USB with it's bandwidth saturation issues, etc. I think this sounds pretty good.

Quoted 1 line

- SCSI scanner sometimes hangs scanning

Sounds like a SCSI configuration problem, possibly termination.

Quoted 1 line

- SCSI CD-ROM/writer sometimes fails to mount CD-ROM (read errors)

See above.

One other thing to check though, I'm assuming your using the onboad SCSI. I've seen at least one of these have "unexplained" SCSI problems that turned out to be caused by the SCSI connector on the motherboard grounding out to the case. The connector is precariously close to the metal grouding pad where the board is commonly mounted to the case. A small insulator did the trick in the cases I've seen (in one case it was total bus failure on channel A, in the other it was simply intermittent errors).

Quoted 1 line

- Mangled sound output from AC97 codec

I think this is largely caused by the VIA audio driver included with standard linux. I've had no end of trouble with it. I use ALSA on my VIA chip and it works mostly without trouble. I'd suggest at least giving it a try.

Quoted 1 line

- PCI bus cannot be overclocked to more than 34.5 MHz

Uh, what do you expect? The spec is 33Mhz, you're not guaranteed more than that, that's why they have a spec.

Later,
Tom

#2 lore raw
In reply to Stanislav Brabec

Původní zpráva (Tom Sightler, St  5. září 2001, 19:14:26 GMT):

Quoted 7 lines
Quoted 6 lines

I have Microstar mainboard MSI K7T266 Pro (MS-6380) with VIA KT266 chipset (VIA 8233), Athlon 1200/266, linux-2.4.9

Does anybody with this mainboard have some problems (or using it succesfull), or should I suspect some bad setup / problematic PCI card or more particular bugs?

Quoted 7 lines

We have a machine with this motherboard and a 1.4Ghz Athlon CPU and use it without significant problems.

I don't find any of these to point toward PCI problems, are there other reasons you would suspect PCI?

Exactly, I don't suspect PCI, I suspect problems with 8233 chip setup (or some device connected to it). Maybe it is not correct, but I don't beleive there are four independent problems with devices connected via VIA 8233.

There is actually one problem I'we forgotten:

About once per 50 pages printed via parport in graphic mode the page goes out mangled. Playing around with DMA mode/IRQ mode/polling, there only changes behavior (hanged printing / long timeouts every few pages / mangled page after few minutes timeout / mangled page)

Quoted 6 lines
Quoted 1 line

- SCSI scanner sometimes hangs scanning

Sounds like a SCSI configuration problem, possibly termination.

Quoted 1 line

- SCSI CD-ROM/writer sometimes fails to mount CD-ROM (read errors)

See above.

One other thing to check though, I'm assuming your using the onboad SCSI.

No, I have version without SCSI controller, I am using DC315U:
SCSI storage controller: Tekram Technology Co.,Ltd. TRM-S1040 (rev 01) I don't expect termination problems:
1) I have moved whole SCSI subsystem (incl. SCSI card) from my old machine (Cyrix i686MX200). There were no problems.
2) The problems CD-ROM is only while mounting or checking for msinfo. Never while burning or reading already mounted CD-ROM.

Quoted 6 lines
Quoted 1 line

- Mangled sound output from AC97 codec

I think this is largely caused by the VIA audio driver included with standard linux. I've had no end of trouble with it. I use ALSA on my VIA chip and it works mostly without trouble. I'd suggest at least giving it a try.

I have downloaded latest ALSA and compiled via8233 driver. I have also communicated with ALSA developers and they say they have no problems. Maybe there is a problem ALSA knows nothing about K7T266 Pro's AC97 codec (VIA VT1611A, identified as 0x49434943 ICI). Again, the problems with sound is random and occurs only during chip initialize and frequency change. The rest of time sound plays either correctly or buggy (depending whether initialization was succesful).

Quoted 6 lines
Quoted 1 line

- USB PC2PC driver sometimes looses data errors (cca once per 20MB)

This actually sounds pretty good, do you really mean one error per 20MB? I've never used the PC2PC driver but knowing the nature of USB with it's bandwidth saturation issues, etc. I think this sounds pretty good.

I don't have many experiences with USB and their drivers, but these errors cause timeouts and sometimes connection loosing. Maybe it can be a driver bug (usbnet driver for GL620USB I was created from Genesys Logic source codes and it was my first kernel stuff).

Quoted 3 lines
Quoted 1 line

- PCI bus cannot be overclocked to more than 34.5 MHz

Uh, what do you expect? The spec is 33Mhz, you're not guaranteed more than that, that's why they have a spec.

Well I have changed everything to observe number of problems (BIOS setups, under/overclocking). As far as machine was stable when underclocked (900 MHz processor, 100 MHz FSB, 33 MHz PCI), the problems were nearly the same. Then I have tried overclocking. At 35 MHz / 140 MHz FSB on PCI, the USB started to make significantly more bugs (once per 100 kB).

Quoted 2 lines

Later,
Tom

Thanks for your info

Signature · 1 line
Stanislav Brabec