Skip to contentSkip to conversation

USB lockup on Thinkpad i1300

DISCUSSION Taral 2 participants 3 messages Sep 22, 2001

lore
Share & tools
lore

Taral

author
#0 lore raw

My thinkpad happily locks up with both 2.4.9 and 2.4.10-pre14 when I load usb-ohci. Tracing with kdb shows that the system locks up right after executing this: (usb-ohci.c:2137)

        /* HC Reset requires max 10 ms delay */
        writel (OHCI_HCR,  &ohci->regs->cmdstatus);

Anyone have any idea? The processor apparently never gets to the next instruction.

[Cc: me please, I'm not on this list.]

P.S. System chipset is ALi:

00:14.0 USB Controller: Acer Laboratories Inc. [ALi] M5237 USB (rev 03) (prog-if 10 [OHCI])
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at 82400000 (32-bit, non-prefetchable) [size=4K]

Shares IRQ with cardbus bridge and lcd controller.

Signature · 4 lines
Taral <[email protected]>
This message is digitally signed. Please PGP encrypt mail to me.
"Any technology, no matter how primitive, is magic to those who don't
understand it." -- Florence Ambrose
#1 lore raw
Quoted 8 lines

load usb-ohci. Tracing with kdb shows that the system locks up right after executing this: (usb-ohci.c:2137)

        /* HC Reset requires max 10 ms delay */
        writel (OHCI_HCR,  &ohci->regs->cmdstatus);

Anyone have any idea? The processor apparently never gets to the next instruction.

As an experiment stick

	unsigned long flags;


	save_flags(flags);
	cli();
	printh("Not dead yet\n");
	/* HC ...
	..

	printk("Writel returned\n");
	readl(&ohci->regs->cmdstatus);
	printk("Write definitely occurred now\n");
	restore_flags(flags);
	printk("Ok with IRQ on\n");

Into that piece of code.

That will tell you if for example it is an IRQ storm of some kind.

author
#2 lore raw
In reply to Taral
Quoted 11 lines · Alan Cox
	save_flags(flags);
	cli();
	printh("Not dead yet\n");
	/* HC ...
	..

	printk("Writel returned\n");
	readl(&ohci->regs->cmdstatus);
	printk("Write definitely occurred now\n");
	restore_flags(flags);
	printk("Ok with IRQ on\n");

I get "Not dead yet" then nothing.

Signature · 4 lines
Taral <[email protected]>
This message is digitally signed. Please PGP encrypt mail to me.
"Any technology, no matter how primitive, is magic to those who don't
understand it." -- Florence Ambrose