Skip to contentSkip to conversation

Probing for Kernel Configuration

DISCUSSION Eric Bresie 1 participant 1 message Nov 7, 2001 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Yes...doesn't that kind of assume you have all the necessary modules compiled and available for the kernel you are using?? What I am proposing is a probe that creates a config for use with compiling the kernel.

That doesn't work when you are trying out a new kernel...If I download linux 2.4.x which has all sorts of new modules...I don't think kudzu will setup your kernel source configuration options, recompile the modules and then activate the modules.

Also that is distribution specific also, which is seperate from the kernel itself..

Eric

Quoted 4 lines

From: Shawn [mailto:[email protected]]On Behalf Of EvilTypeGuy
Sent: Wednesday, November 07, 2001 2:00 PM

It exists already, it's called kudzu for RedHat, and other things for

other

Quoted 1 line

systems...At bootup time a redhat system will probe for new hardware using

kudzu

Quoted 5 lines

and then make sure the appropriate modules are loaded if it recognizes the hardware...

Quoted 1 line · Eric Bresie

I just recently installed a new version of Redhat 7.2 and had problems

with

Quoted 2 lines
Quoted 2 lines

some of my devices not being supported as part of the stock installation...this got me thinking...I noticed that when I did a lspci

that a

Quoted 1 line
Quoted 1 line

majority of my hardware was identified, but there was no guarantee that

the

Quoted 3 lines
Quoted 3 lines

module to support that hardware is present in the kernel or configured..

Is it possible prior to kernel configuration to perhaps have something

like a

Quoted 1 line
Quoted 1 line

make newconfig or make probe-config to probe the system and give a guess

as to

Quoted 1 line
Quoted 1 line

what modules are needed for a given system...I guess you could think of

it

Quoted 3 lines
Quoted 3 lines

kind of as a plug-n-play for kernel configuration.

I could see how this might require some mapping of hardware probed

information

Quoted 1 line
Quoted 1 line

to kernel config options which would then enable them (and if

appropriate set

Quoted 1 line
Quoted 1 line

to current settings). And also might require some default utilities

like the

Quoted 6 lines
Quoted 6 lines

pci utilities, the usb utilities, scsi, etc...

Any comments?

Eric Bresie
[email protected]