Skip to contentSkip to conversation

failed assertion in tcp.c

DISCUSSION Nathan Poznick 1 participant 1 message Nov 27, 2001

lore
Share & tools
lore
#0 lore raw

Hello,

I've got a machine running 2.4.14+xfs, it's a dual-p3 with 4gb ram (CONFIG_HIGHMEM4G=y), and it's using an onboard eepro100. The machine is relatively heavily loaded with people doing compiles, and running network/memory/disk intensive tasks, and I often see messages such as these in the syslog:

Nov 27 12:23:42 dpdred1 kernel: eth0: can't fill rx buffer (force 0)! 
Nov 27 12:23:54 dpdred1 last message repeated 19 times
Nov 27 12:23:54 dpdred1 kernel: eth0: can't fill rx buffer (force 1)! 
Nov 27 12:23:57 dpdred1 kernel: eth0: can't fill rx buffer (force 0)! 
Nov 27 12:24:01 dpdred1 last message repeated 7 times
Nov 27 12:24:01 dpdred1 kernel: eth0: card reports no resources. 
Nov 27 12:24:01 dpdred1 kernel: eth0: restart the receiver after a
 possible hang.

Normally, everything seems fine, despite the eth0 messages. Today however, it stopped responding over the network, and when I got over to the console, I found this as well:

Nov 27 13:15:56 dpdred1 kernel: KERNEL: assertion (flags&MSG_PEEK)
 failed at tcp.c(1463):tcp_recvmsg 
Nov 27 13:15:56 dpdred1 kernel: recvmsg bug: copied 6671AD12 seq 6671B2BA 
Nov 27 13:15:56 dpdred1 kernel: KERNEL: assertion (flags&MSG_PEEK)
 failed at tcp.c(1463):tcp_recvmsg 
Nov 27 13:15:56 dpdred1 kernel: recvmsg bug: copied 6671AD12 seq 6671B2BA

Since people needed to use the machine, I didn't spend any time right then trying to get any further insight into the problem, I just rebooted it. Does anyone have any insight into what might cause this? (and how I can avoid it in the future?)

Signature · 5 lines
Nathan Poznick <[email protected]>
PGP Key: http://drunkmonkey.org/pgpkey.txt

In a fight between you and the world, bet on the world.
-- Franz Kafka