Journaling pointless with today's hard disks?
Quoted 6 lines · Richard B. Johnson
It isn't that easy! Any kind of power storage within the drive would have to be isolated with diodes so that it doesn't try to run your motherboard as well as the drive. This means that +5 volt logic supply would now be 5.0 - 0.6 = 4.4 volts at the drive, well below the design voltage. Use of a Schottky diode (0.34 volts) would help somewhat, but you have now narrowed the normal power design-margin by 90 percent, not good.
Another interesting possibility would be to use the momentum of the spinning platters and motor assembly to power the drive electronics, simply by using the motor as a generator. When power fails during a write, use the current generated by the motor to finish the write.
Just a wild idea...
Cheers//Frank
Signature · 9 lines
WWWWW _______________________
## o o\ / Frank de Lange \
}# \| / \
##---# _/ <Hacker for Hire> \
#### \ +31-320-252965 /
\ [email protected] /
-------------------------
[ "Omnis enim res, quae dando non deficit, dum habetur
et non datur, nondum habetur, quomodo habenda est." ]Quoted 4 lines · Frank de Lange
Another interesting possibility would be to use the momentum of the spinning platters and motor assembly to power the drive electronics, simply by using the motor as a generator. When power fails during a write, use the current generated by the motor to finish the write.
Non-trivial because you'd have to adjust filters and code rate to the actual platter speed (which goes down as energy is drained and moved elsewhere) and design that beast to actually be a generator.
Probably too much development effort for a situation which should not happen too often.