Skip to contentSkip to conversation

agpgart & i810 & agp_bridge.gatt_table question

DISCUSSION Abraham vd Merwe 1 participant 1 message Dec 7, 2001

lore
Share & tools
lore
#0 lore raw

Hi!

What is agp_bridge.gatt_table used for on the Intel 810 series?

Looking at agpgart_be.c, it seems either 64k or 32k is allocated (depending on the value of MISCC register) and all the entries is set to the scratch page for i810, but that gatt table is never used except in intel_i810_insert_entries() where we have this check:

------------< snip <------< snip <------< snip <------------

    for (j = pg_start; j < (pg_start + mem->page_count); j++) {
        if (!PGE_EMPTY(agp_bridge.gatt_table[j])) {
            return -EBUSY;
        }

------------< snip <------< snip <------< snip <------------

!PGE_EMPTY roughly translates to agp_bridge.gatt_table[j] && agp_bridge.gatt_table[j] != agp_bridge.scratch_page.

Of course, this is always true, so we'll never return EBUSY there, but the whole thing is silly because we're wasting precious 64k/32k physical contigious ram and valuable CPU time for this useless check...

The other odd thing I noticed is that this gatt_table is initialized in agp_backend_initialize(). Look at the 'if (agp_bridge.create_gatt_table()) {' line in that function. For i810 this translates to agp_generic_create_gatt_table(), which goes and queries agp_bridge.current_size.

The problem is that at that stage agp_bridge.current is not initialized yet, so we're going to get bogus sizes. (Note: this doesn't only go for i810, but for any chipset that uses agp_generic_create_gatt_table and doesn't have a size type LVL2_APER_SIZE (for which that function doesn't work))

Signature · 15 lines
Regards
 Abraham

Experience is what you get when you were expecting something else.

__________________________________________________________
 Abraham vd Merwe - 2d3D, Inc.

 Device Driver Development, Outsourcing, Embedded Systems

  Cell: +27 82 565 4451         Snailmail:
   Tel: +27 21 761 7549            Block C, Antree Park
   Fax: +27 21 761 7648            Doncaster Road
 Email: [email protected]         Kenilworth, 7700
  Http: http://www.2d3d.com        South Africa