swapping problem on kernel >= 2.4.14
I have tried to change to kernel 2.4.16 from 2.4.13 and my system crashes every time it starts using swap. This is the case down to 2.4.14 even when it is built using default options. My system is a AMD duron with 128MB of RAM and two swap partitions both 128MB on my non boot hard drive.
could someone please fix this
thanks
Quoted 6 lines · Caleb Moore
I have tried to change to kernel 2.4.16 from 2.4.13 and my system crashes every time it starts using swap. This is the case down to 2.4.14 even when it is built using default options. My system is a AMD duron with 128MB of RAM and two swap partitions both 128MB on my non boot hard drive.
could someone please fix this
You can significantly raise probability of this being fixed with some
investigation: does it crash with one swap partition? without swap partitions? with swap file? does it produce an oops? etc
--
vda
Quoted 9 lines
Quoted 2 lines
I have tried to change to kernel 2.4.16 from 2.4.13 and my system crashes
You can significantly raise probability of this being fixed with some
investigation: does it crash with one swap partition? without swap partitions?
with swap file? does it produce an oops? etc
--
vda
Ok I checked my system with one swap partition, no swap partitions and a swap file. One partition resulted in a crash but after a longer duration (two or three times as long. I cannot understand this). A swap file acted in a similar way to the single swap. After removing all swap the system was as stable as linux is rightly reputed to be.
The kernel does produce an oops when i crash it but for some reason the screen blacks out a few minutes later and i am unnable to finish recording the sym-debug stuff and cannot get useful information from it. It is not logged by klogd and I don't get much further then the registers. The message It gives me is unnable to handle kernel paging request at virtual address 00015e00 although of course this adress changes.
Is there anything else I can do?
Quoted 6 lines · Caleb Moore
Ok I checked my system with one swap partition, no swap partitions and a swap file. One partition resulted in a crash but after a longer duration (two or three times as long. I cannot understand this). A swap file acted in a similar way to the single swap. After removing all swap the system was as stable as linux is rightly reputed to be.
Quoted 6 lines
The kernel does produce an oops when i crash it but for some reason the screen blacks out a few minutes later and i am unnable to finish recording the sym-debug stuff and cannot get useful information from it. It is not logged by klogd and I don't get much further then the registers. The message It gives me is unnable to handle kernel paging request at virtual address
00015e00although of course this adress changes.
Sorry, but this info is not enough. Guys most likely won't be able to fix this if they don't know where your kernel crashed, CPU registers at the crash time etc.
Screen blanking: some power-saving? Try to disable. Maybe you can photograph it if it turns off by itself too fast? :-) --
vda