Skip to contentSkip to conversation

What about a "generic" ISA/BIOS PnP layer ?

DISCUSSION Jerome AUGE 1 participant 1 message Dec 18, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

I've tweaked the opl3sa2 driver to use PnP BIOS device detection/registration, in order to load "automagically" the module without specifying the io/dma/irq stuff on my system that do not support ISA PnP.

So, for compatibility, I end up using both ISA and BIOS PnP functions. I've got to handle all the configuration cases (CONFIG_ISAPNP/CONFIG_BIOSPNP). I first try with ISA, if it fails then I try with BIOS, then I've got to remind what method (ISA or BIOS) was used in order to correctly unload/remove the driver by calling the correct isapnp_ or pnpbios_ functions. And I had to duplicate all the isapnp functions/struct to pnpbios equivalent.

So I'd like to know what do you think about making a generic PnP layer that would "hide" and automatically select to use ISA or BIOS functions ?

The driver code would use the "generic PnP" functions without checking all the configuration cases. And the "generic PnP" layer would decide if it uses ISA or BIOS and make/forward the correct calls.

This way, we could write drivers that would work indifferently with ISA PnP or BIOS PnP. If the system support ISA PnP, then the "generic" PnP layer would use ISA functions, and if the system support only BIOS PnP then it would use BIOS functions.

Is the "new driver model" from P. Mochel supposed to do this ? or is it just for PCI devices ?