Skip to contentSkip to conversation

Changing KB, MB, and GB to KiB, MiB, and GiB in Configure.help.

DISCUSSION Stuart Lynne 1 participant 1 message Dec 21, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 5 lines

If you would pay more attention, you can see that on most drives there is a small note that says: 1MB = 1000000 bytes. This is why the drive capacity is smaller than the manufacturer says.

http://www.seagate.com/products/discsales/discselect/A1a2.html#cap

Capacity:
Capacity is the amount of data that the drive can store, after formatting. Most disc drive companies, including Seagate, calculate disc capacity based on the assumption that 1 megabyte = 1000 kilobytes and 1 gigabyte=1000 megabytes.

Disks have a natural measurement of capacity based on an integral number of 512byte blocks. So kilobytes (1024) makes sense for them.

The only marketing wizardry is to use the smaller of:

1 megabyte = 1000 kilobytes

instead of:

1 megabyte = 1024 kilobytes

There are valid arguements for both interpretations.

Signature · 4 lines
                                            __O 
Lineo - For Embedded Linux Solutions      _-\<,_ 
PGP Fingerprint: 28 E2 A0 15 99 62 9A 00 (_)/ (_) 88 EC A3 EE 2D 1C 15 68
Stuart Lynne <[email protected]>         www.lineo.com         604-461-7532