IDE Harddrive Performance
Quoted 7 lines
hda: Maxtor 93073U6, ATA DISK drive
hdc: Maxtor 90840D6, ATA DISK drive
/dev/hda:
Timing buffered disk reads: 64 MB in 86.98 seconds =753.46 kB/sec/dev/hdc:
Timing buffered disk reads: 64 MB in 5.63 seconds = 11.37 MB/sec
I'm in the same boat with my Maxtor 54098U8. It has been getting progressively slower. Two weeks ago I was getting a whopping 3MB/s, now I get:
/dev/hda:
Timing buffered disk reads: 64 MB in 115.29 seconds =568.44 kB/sec
My CDROM (ide-scsi) is faster than this!
# time dd if=/dev/scd0 of=/dev/null count=32k bs=512 real 0m8.443s
= 1.8MB/sec
The wierd thing is that I don't get any errors, but I have just switched from emacs to vi. :-) I ran Maxtor's powermax.exe and their 90sec test hadn't finished after 20 minutes so I rebooted. :-(
Same results with 2.4.9 - 2.4.17.
-Jim
VP_IDE: VIA vt82c686a (rev 14) IDE UDMA66 controller on pci00:07.1
# hdparm /dev/hda
/dev/hda:
multcount = 16 (on) I/O support = 1 (32-bit) unmaskirq = 1 (on) using_dma = 1 (on) keepsettings = 0 (off) nowerr = 0 (off) readonly = 0 (off) readahead = 8 (on)
geometry = 4865/255/63, sectors = 78165360, start = 0
busstate = 1 (on)
Quoted 25 lines · Jim Radford
Quoted 7 lines
hda: Maxtor 93073U6, ATA DISK drive
hdc: Maxtor 90840D6, ATA DISK drive
/dev/hda:
Timing buffered disk reads: 64 MB in 86.98 seconds =753.46 kB/sec/dev/hdc:
Timing buffered disk reads: 64 MB in 5.63 seconds = 11.37 MB/secI'm in the same boat with my Maxtor 54098U8. It has been getting
/dev/hda:
Timing buffered disk reads: 64 MB in 115.29 seconds =568.44 kB/sec
Same results with 2.4.9 - 2.4.17.VP_IDE: VIA vt82c686a (rev 14) IDE UDMA66 controller on pci00:07.1# hdparm /dev/hda
/dev/hda:multcount = 16 (on) I/O support = 1 (32-bit) unmaskirq = 1 (on) using_dma = 1 (on) keepsettings = 0 (off) nowerr = 0 (off) readonly = 0 (off) readahead = 8 (on)
Quoted 2 lines
geometry = 4865/255/63, sectors = 78165360, start = 0
busstate = 1 (on)
Haven't had any trouble 2.4.x - 2.4.17 using the same model drive.
PDC20268: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER
hde: Maxtor 54098U8, ATA DISK drive
hdg: Maxtor 54098U8, ATA DISK drive
with 2.4.17 I get ~28.96MB/sec with hdparm -t /dev/hdx
# hdparm /dev/hde multicount = 16 (on) I/O support = 3 (32bit w/sync) unmaskirq = 0 (off) using_dma = 1 (on) keepsettings = 0 (off) nowerr = 0 (off) readonly = 0 (off) readahead = 8 (on) geometry = 4111/255/63, sectors = 66055248, start = 0
Quoted 8 lines · Jim Radford
Quoted 7 lines
hda: Maxtor 93073U6, ATA DISK drive
hdc: Maxtor 90840D6, ATA DISK drive
/dev/hda:
Timing buffered disk reads: 64 MB in 86.98 seconds =753.46 kB/sec/dev/hdc:
Timing buffered disk reads: 64 MB in 5.63 seconds = 11.37 MB/sec
Quoted 6 lines
I'm in the same boat with my Maxtor 54098U8. It has been getting progressively slower. Two weeks ago I was getting a whopping 3MB/s, now I get:
/dev/hda:
Timing buffered disk reads: 64 MB in 115.29 seconds =568.44 kB/sec
I just ripped my machine apart, cleaned it out and made sure all the connections are snug. I didn't find anything glaringly wrong inside, so my current conclusion is that my machine just gets too durn hot for the drive to function properly. I'm going to periodically test my throughput to see if it degrades over time. See if taking your machine down for a few hours helps things out. If so we can yell at Maxtor, otherwise its back on the bug hunt.
Thanks to everyone who sent suggestions! Hopefully I'm through with this hiccup. :)
Signature · 1 line
akk~