Skip to contentSkip to conversation

Configure.help entry fix

DISCUSSION Steven Pritchard 1 participant 1 message Dec 28, 2001

lore
Share & tools
lore
#0 lore raw

Then entry in Configure.help for CONFIG_BLK_DEV_3W_XXXX_RAID starts out "3ware is the only hardware ATA-Raid product in Linux to date." This is a mistake, since the driver for the Adaptec 2400A card (dpt_i2o) is in the kernel.

I've included a patch below to fix that, plus add a note about a data corruption issue that users should be aware of. I suppose the entry should probably also include the standard "If you want to compile this driver as a module..." block also...

On a side note, shouldn't CONFIG_BLK_DEV_3W_XXXX_RAID really be something like CONFIG_SCSI_3W_XXXX_RAID?

Steve

Signature · 22 lines
[email protected]           | Southern Illinois Linux Users Group
(618)398-7360             | See web site for meeting details.
Steven Pritchard          | http://www.silug.org/

--- Documentation/Configure.help.orig	Fri Dec 21 11:41:53 2001
+++ Documentation/Configure.help	Thu Dec 27 23:34:49 2001
@@ -917,9 +917,13 @@
 
 3ware Hardware ATA-RAID support
 CONFIG_BLK_DEV_3W_XXXX_RAID
-  3ware is the only hardware ATA-Raid product in Linux to date.
-  This card is 2,4, or 8 channel master mode support only.
-  SCSI support required!!!
+  This driver supports the 3ware Escalade 5000, 6000, and 7000-series
+  IDE RAID controllers.
+
+  Note that RAID 5 on 6000-series controllers requires a recent
+  firmware revision.  Running old firmware or old versions of the
+  driver on a degraded RAID 5 array can cause data corruption on the
+  array.  See 3ware's web site for firmware updates.
 
   <http://www.3ware.com/>