Skip to contentSkip to conversation

how to map network cards ?

DISCUSSION Jesse Pollard 2 participants 2 messages Dec 31, 2001

lore
Share & tools
lore
#0 lore raw

Girish Hilage <[email protected]>:

Quoted 6 lines

Hello everybody,

This is my first mail to the list. I want to know, what /sbin/lspci outputs are nothing but the contents of '/proc/bus/pci/devices' in a readable form?

And if so how do I know which entry implies which network interface (e.g. eth0, eth1 etc.)?

You don't.

There is no fixed method, though the following may help:

1. eth0 is assigned to the first device identified. This works if you have multiple interfaces (using different drivers), then the order the drivers are loaded will define which is eth0 - I do this for a system with mixed 3c509 (ISA), and 3c905 (PCI) interfaces.
2. In a muli-interface environment with (say) two 3c509 - the order happens to be in bus order. This has implied that the slot number it is plugged in determines which is eth0. In my case a system has two PCI 3c905C interfaces, the first at 00:0e.0, and the second at 00:0f.0. The 0e.0 interface appears as eth0.

Note: if one of the interfaces is unplugged/fails dramatically , the bus scan will assign the FIRST interface located as eth0. The only way to determine the ACTUAL eth0 is via mac number and trial and error.

I configure ONE interface (all others are down), then plug in to a working network.

If I can ping the other machine then I know which network a given interface is on - label it.

Now down that interface, and initialize another one. Repeat until all interfaces are identified.
-------------------------------------------------------------------------
Jesse I Pollard, II
Email: [email protected]

Any opinions expressed are solely my own.

#1 lore raw
Quoted 2 lines · Jesse Pollard

The only way to determine
the ACTUAL eth0 is via mac number and trial and error.

not correct, as noted in other e-mail.

Quoted 8 lines

I configure ONE interface (all others are down), then plug in to a working network.

If I can ping the other machine then I know which network a given interface is on - label it.

Now down that interface, and initialize another one. Repeat until all interfaces are identified.

also note that one can rename interfaces, or in the future they might appear out-of-order. To only way to be obsolutely certain where a network device is on the PCI bus is ETHTOOL_GDRVINFO.

Jeff

Signature · 3 lines
Jeff Garzik      | Only so many songs can be sung
Building 1024    | with two lips, two lungs, and one tongue.
MandrakeSoft     |         - nomeansno