Skip to contentSkip to conversation

pcmcia problems with IDE & cardbus

DISCUSSION dhinds 1 participant 1 message Feb 27, 2002

lore
Share & tools
lore

dhinds

author
#0 lore raw
Quoted 3 lines · Herbert Rosmanith

"unable to get IRQ 10" is somewhat funny, since IRQ-10 is used by the cardbus device. what I don't understand is if the IDE-drive sould get its own interrupt or not.

The card should (must) share the PCI interrupt with the CardBus bridge device. However, the IDE driver assumes that it should have exclusive use of the interrupt, because it doesn't believe that this is a PCI IDE device (well, it is sort of an ISA IDE device sitting behind a PCI bridge).

Quoted 4 lines

and finally an ugly detail: when removing the ComapctFlash and unloading pcmcia, ide_cs will still have the ioport-ressources clailed form /proc/ioport. seems there's a call to *_unregister missing.

The ide_cs driver does call ide_unregister(). The problem is that the IDE driver doesn't clean up properly if you hot-eject an interface that has active devices associated with it. Use "cardctl eject" before you eject an IDE card.

-- Dave