[email protected]
Bcc:
Subject: Re: Linux 2.5.5-dj1 - Bug Reports
Reply-To:
In-Reply-To: <[email protected]>; from [email protected] on Thu, Feb 28, 2002 at 11:59:54AM -0500
Quoted 14 lines
Quoted 6 lines · Dave Jones
Quoted 5 lines
Quoted 4 lines
It compiled fine. When I booted up everything looked normal with the exception of a
eth1: going OOM
message that kept scrolling down the screen. My eth1 is a natsemi card.Quoted 7 lines
Quoted 2 lines
That's interesting. Probably moreso for Manfred. I'll double check I didn't goof merging the oom-handling patch tomorrow.
Ditto here on my natsemi. It hasn't really spit out the error since boot, about 12 hours ago. Card has been mainly idle, only used to connect via crossover cable to my laptop, which hasn't been used much in that time.
Quoted 6 lines
dj2 is showing the same behavior, but I found out that the messages continue to be printed 100 times/second until I ping-flooded the machine on the other end of that card. The minimal DHCP traffic prior to the ping flood was not enough to make it stop.
Hope this helps narrow down the problem some.
Yup, Manfred is aware of this, but hasn't had time to look into it yet.
Signature · 2 lines
| Dave Jones. http://www.codemonkey.org.uk | SuSE Labs