DiskOnChip 2000 and Millenium support in GRUB bootloader
Quoted 7 lines · Ilguiz Latypov
inform that DoC Millennium and DoC Millennium Plus feature a Download Engine which takes care of copying the flash image into the read-only area available at offset 0 of the window.
Apparently, the XIP IPL doesn't need the DoC 2000 trick with duplicating the code for 256-byte and 512-byte page size devices at offsets
0x100and0x200respectively.
Ilguiz,
With a DoC Millennium , the doc_stage1 logic will always copy the 256-byte-page code to RAM, regardless of the chip type. In fact, because of the Millennium's 512 byte "boot block" window, the actual 512-byte page code is never directly accessible -- it is always located at 0x200 in this case.
As I mentioned previously, my hack to get my part to work was simply to force the 512-byte-page code to 0x100, and everything worked great. If there are 256-byte-page parts, this obviously won't work.
One alternative is to have both 256- and 512-byte code located at 0x100..0x1FF, and determine (at run time) which type of part we have.
One way of doing this would be to have a small look-up table, and based on the chip ID, determine the part type.
Another way (which I've already tested) is to read from flash address 0x200, using the 256-byte-page access method. If we are indeed on a 256-byte device, the word at 0x200 will always match the code word at %cs:doc_stage1b.
In a 512-byte device, reading this address actually reads 0x400, which will *most likely* not match, as it is actually stage 2 GRUB code. We could compare more bytes, if necessary, to reduce the possibility that this could happen.
Maybe there is an easier, cleaner way to handle this problem -- but I haven't found it yet. Does it make sense to pursue this further?
Regards,
Mark