Alsa 0.9 / chipset 8233 : audio OK but not Midi
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi Lionel and others,
I've a KT333 motherboard with the VIA8233A chipset, and I've the same problem as you. "cat /proc/asound/oss/sndstat" gives me the following output:
----------
Sound Driver:3.8.1a-980706 (ALSA v0.9.0rc2 emulation code)
Kernel: Linux tussen.huis 2.4.19-gentoo-r7 #2 SMP Fri Jun 14 18:48:35 WEST 2002 i686
Config options: 0
Installed drivers:
Type 10: ALSA emulation
Card config:
VIA 8233 at 0xe000, irq 11
Audio devices:
0: VIA 8233 (DUPLEX)
Synth devices: NOT ENABLED IN CONFIG
Midi devices: NOT ENABLED IN CONFIG
Timers:
7: system timer
Mixers:
0: mixer00
----------
If I try to load the snd-seq-oss module (I think that's the problem) I get these errors:
----------
tussen root # modprobe snd-seq-oss /lib/modules/2.4.19-gentoo-r7/kernel/sound/acore/seq/oss/snd-seq-oss.o:init_module: Device or resource busy
Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg/lib/modules/2.4.19-gentoo-r7/kernel/sound/acore/seq/oss/snd-seq-oss.o: insmod /lib/modules/2.4.19-gentoo-r7/kernel/sound/acore/seq/oss/snd-seq-oss.o failed /lib/modules/2.4.19-gentoo-r7/kernel/sound/acore/seq/oss/snd-seq-oss.o: insmod snd-seq-oss failed
----------
When I look at my dmesg, I see this:
----------
ALSA ../../../alsa-kernel/core/seq/oss/seq_oss.c:223: can't register device seq
ALSA ../../../alsa-kernel/core/seq/oss/seq_oss.c:223: can't register device seq
----------
Perhaps it's a problem with the driver or so? Sound is working very well, except for midi. Anyone with a VIA8233A who got midi working?
Thanks,
Niek.
Quoted 141 lines · Vintenat Lionel
Hi everybody,
I've just bought a PC mainly in order to control a Midi synthesizer.
This PC is based on a DFI motherboard (AD70-SC model) with KT266A/VT8233 Via chipset. I've installed the RedHat 7.3 distribution of Linux which is based on 2.4.18 kernel. At the beginning, sound didn't work at all. So I searched through internet and found drivers for VT8233 chipset and 2.4.18 kernel at the Via website (http://www.viaarena.com). Then sound started to work but not midi (still no device for/dev/sequencer).Then I've installed Alsa 0.9rc2 (drivers, libs and utils packages).
Compilation (--with-debug=full --with-sequencer=yes --with-oss=yes --with-isapnp=no) and installation ran without any problem, but the situation remains the same : sound works very well (I can play samples, movies, etc.) but midi seems to be completely "ignored", both by Alsa (jazz complains that it can't find any midi port) and OSS emulation (see below/proc/asound/oss/sndstat).Here is my
/etc/modules.conf:alias
parport_lowlevelparport_pc
alias char-major-116 snd
alias snd-card-0 snd-via8233
alias char-major-14 soundcore
alias sound-slot-0 snd-card-0
alias sound-service-0-0 snd-mixer-oss
alias sound-service-0-1 snd-seq-oss
alias sound-service-0-3 snd-pcm-oss
alias sound-service-0-8 snd-seq-oss
alias sound-service-0-12 snd-pcm-oss
alias usb-controller usb-uhciHere is what I get with lsmod command after login in KDE environment :
Module Size Used by Not tainted nls_iso8859-1 3488 1 (autoclean) nls_cp437 5120 1 (autoclean) vfat 12092 1 (autoclean) fat 37432 0 (autoclean) [vfat] snd-pcm-oss 50596 1 (autoclean) snd-mixer-oss 12896 0 (autoclean) [snd-pcm-oss] snd-via8233 8100 1 (autoclean) snd-pcm 78688 0 (autoclean) [snd-pcm-oss snd-via8233] snd-timer 15840 0 (autoclean) [snd-pcm] snd-ac97-codec 30564 0 (autoclean) [snd-via8233] snd 47080 0 (autoclean) [snd-pcm-oss snd-mixer-oss snd-via8233 snd-pcm snd-timer snd-ac97-codec] soundcore 6692 3 (autoclean) [snd] binfmt_misc 7556 1 autofs 12132 0 (autoclean) (unused) ipchains 43528 7 ide-cd 30272 0 (autoclean) cdrom 32224 0 (autoclean) [ide-cd] usb-uhci 24452 0 (unused) usbcore 73216 1 [usb-uhci] ext3 67136 5 jbd 49400 5 [ext3]As it can be seen : all sound modules are well loaded except sequencer
and midi ones.Now here is the result of "cat
/proc/asound/cards" :0 [card0 ]: VIA8233 - VIA 8233
VIA 8233 at0xe000, irq 5And now the result of "cat
/proc/asound/oss/sndstat" :Sound Driver:3.8.1a-980706 (ALSA v0.9.0rc2 emulation code)
Kernel: Linux localhost.localdomain 2.4.18-3 #1 Thu Apr 18 07:32:41 EDT 2002 i686 Config options: 0Installed drivers:
Type 10: ALSA emulationCard config:
VIA 8233 at0xe000, irq 5Audio devices:
0: VIA 8233 (DUPLEX)Synth devices: NOT ENABLED IN CONFIG
Midi devices: NOT ENABLED IN CONFIG
Timers:
7: system timerMixers:
0: mixer00I'm worried by those "NOT ENABLED IN CONFIG" messages ! I'm
sure that my motherboard has Midi support because it is written inside the provided manual and a Midi connector is present at the backside of the PC. Moreover I checked the jumpers of the motherboard : they are set to enable audio chipset and anyway sound works well.
I also played with bios settings without more success :
- The "Midi Port Address" parameter is by default set to 330. Other
possible choices are 300, 290 and disable. None works.
- The "Midi Port IRQ" is by default set to 10. Other possible choice is
5. But setting it to 5 makes the "Card config:" become "Via 8233 at0xe000, irq 10" in the/proc/asound/oss/sndstat, but midi remains "NOT ENABLED IN CONFIG".Finally I looked the logged events in
/var/log/messages, but didn't see
any alsa stuff despite the debug switch set to full during compilation. However, there are some "worrying" messages logged by the kernel during reboot. Here they are :Jul 29 23:51:28 localhost syslogd 1.4.1: restart. Jul 29 23:51:28 localhost kernel: klogd 1.4.1, log source = /proc/kmsgstarted. Jul 29 23:51:28 localhost kernel: Linux version 2.4.18-3 ([email protected]) (gcc version 2.96 20000731 (Red Hat Linux 7.3 2.96-110)) #1 Thu Apr 18 07:32:41 EDT 2002 [non significant stuff cut]
Jul 29 23:51:29 localhost kernel: PCI: PCI BIOS revision 2.10 entry at 0xfb400, last bus=1 Jul 29 23:51:29 localhost kernel: PCI: Using configuration type 1 Jul 29 23:51:29 localhost kernel: PCI: Probing PCI hardware Jul 29 23:51:29 localhost kernel: Unknown bridge resource 0: assumingtransparent Jul 29 23:51:29 localhost kernel: PCI: Using IRQ router default [1106/3099] at 00:00.0 Jul 29 23:51:29 localhost kernel: isapnp: Scanning for PnP cards... Jul 29 23:51:29 localhost kernel: isapnp: No Plug & Play device found [non significant stuff cut]
Jul 29 23:51:29 localhost kernel: VP_IDE: IDE controller on PCI bus 00 dev 89 Jul 29 23:51:29 localhost kernel: PCI: No IRQ known for interrupt pin A of device 00:11.1. Please try using pci=biosirq. Jul 29 23:51:29 localhost kernel: VP_IDE: chipset revision 6 Jul 29 23:51:29 localhost kernel: VP_IDE: not 100%% native mode: will probeirqs later Jul 29 23:51:29 localhost kernel: ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx Jul 29 23:51:29 localhost
kernel:VP_IDE: VIA vt8233 (rev 00) IDE UDMA100 controller on pci00:11.1At that point, I'm completely stuck and don't see what to do
now to make my computer communicate with my synthesizer... So any help would be appreciated.Thanks, Lionel
Quoted 8 lines
-------------------------------------------------------
This sf.net email is sponsored by: Dice - The leading online job board for high-tech professionals. Search and apply for tech jobs today!
http://seeker.dice.com/seeker.epl?rel_code=31
_______________________________________________
Alsa-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/alsa-user
-------------------------------------------------------
This sf.net email is sponsored by: Dice - The leading online job board for high-tech professionals. Search and apply for tech jobs today!
http://seeker.dice.com/seeker.epl?rel_code1