Port not active?
I am having the following problem getting AX.25 going on my 2.4.18 RedHat system. The TNC is connected and in KISS mode. The kernel modules "ax25" and "mkiss" are loaded. /etc/ax25/axports has appropriate stuff in it. I give the kissattach command and it completes ok. ifconfig shows the port UP and RUNNING in AX25 mode, with the correct HWaddr.
But when I try to use it, for example with a "call" command, I get the messages:
axconfig: port vhf not active
call: no AX.25 port data configured
Am I missing a step somewhere?
Versions are:
Kernel 2.4.18, with AX.25 stuff included
libax25 0.0.10
kissattach 0.0.8
call 0.0.6
Quoted 6 lines · pd
I am having the following problem getting AX.25 going on my 2.4.18 RedHat system. The TNC is connected and in KISS mode. The kernel modules "ax25" and "mkiss" are loaded.
/etc/ax25/axportshas appropriate stuff in it. I give the kissattach command and it completes ok. ifconfig shows the port UP and RUNNING in AX25 mode, with the correct HWaddr.
Quoted 6 lines
But when I try to use it, for example with a "call" command, I get the messages:
axconfig: port vhf not active
call: no AX.25 port data configuredAm I missing a step somewhere?
Did you assign an IP address to the port? You need to give it an IP address, even if you don't use IP.
You could use 10.0.0.1 if you don't have an IP address assign to you.
73, PE1ICQ Arno Verhoeven
--------------------------------
AX.25 pe1icq@pi8zaa.#nbo.nld.eu smtp [email protected] inet [email protected]
Quoted 10 lines · pd
I am having the following problem getting AX.25 going on my 2.4.18 RedHat system. The TNC is connected and in KISS mode. The kernel modules "ax25" and "mkiss" are loaded.
/etc/ax25/axportshas appropriate stuff in it. I give the kissattach command and it completes ok. ifconfig shows the port UP and RUNNING in AX25 mode, with the correct HWaddr.But when I try to use it, for example with a "call" command, I get the messages:
axconfig: port vhf not active
call: no AX.25 port data configured
Could you send us your axports file, the kissattach command, and the actual call command.
E.g.
# /etc/ax25/axports # # The format of this file is: # # name callsign speed paclen window description # vhf VE1MCT-8 9600 255 2 144.090 MHz (1200 bps)
root@ve1mct# /usr/sbin/kissattach -m 256 /dev/ttyS0 vhf vhf.ve1mct.ampr.org
ve1mct@ve1mct$ call vhf ve1aeh
Something about your requests for more information jogged my thinking - the IP address has to be *non-zero*!
So instead of putting 0.0.0.0 on the kissattach command I bothered to look up my assigned IP address, tried it, and it worked fine.
Thanks for the help. Now on to the daemons and APRS...