some fan questions

Hi,

I have some questions about ACPI and the fan control. I run a GNU System (Debian Woody) over a Linux kernel 2.4.18.

In /proc/acpi/thermal_zone/THRM/trip_points:

critical (S5):           100 C
passive:                 92 C: tc1=2 tc2=5 tsp=300 devices=0xcffe0d68 

active[0]: 100 C: devices=0xc143c6c8

I think 100 C is too hot for my system! How can i change these values? Can i add new trippoints?

By the way, when i do:

echo -n 0 > /proc/acpi/fan/FAN/state

the state change to 'on', but the machine fan doesnt start.

I have an HP OmniBook XE3.

Thanks in advance!

--
Jose E. Marchesi <jemarch-mXXj517/[email protected]>
GNU Spain http://es.gnu.org
GNUs Not Unix! http://www.gnu.org
--
"And if cynics ridicule freedom, ridicule community... if 'hard nosed realists' say that profit is the only ideal...just ignore them, and use copyleft all the same." -- RMS
---

-------------------------------------------------------
This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE!
https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390