Skip to contentSkip to conversation

HOT SWAP feature is not working! Help!

DISCUSSION Alex 1 participant 1 message Sep 24, 2002 SCSI

lore
Share & tools
lore

Alex

author
#0 lore raw

Hello linux experts,

I hope if i come to the right place

I have a HP 4100 server with LSI 53c1010R SCSI controller. I use RedHat7.3 os with default kernel 2.4.18-3. Also i have 3 scsi drives 36G Ultra3 firmware HP. All thins are ok till here.

I need some help to test HOT SWAP feature for this drives. I read some documentation and i saw that HOT SWAP may work on linux if my driver for scsi-controller support re-scanning the bus!

[snip]
Normal SCSI hardware is not hot-swappable either. It may however work. If your SCSI driver supports re-scanning the bus, and removing and appending devices, you may be able to hot-swap devices. [snip]

I try to check if this feature works for me and don`t. If i remove any scsi drive, this device remain in /proc until will be removed manually, or using a script named rescan-scsi-bus.sh which i found it on google.

I tried to obtain some additional info and i saw that for my scsi-controller has 2 active drivers: one older named sym53cxx.o and one newer named sym53cxx_2.o!
I don`t have for the moment access to this computer but i remember that on default installation, redhat assigned the old driver to my scsi-controller.

I want to know if i change the driver with this new one, i can use the HOT SWAP feature!

Are necessary additional settings to be made when i load the new driver or on the system configuration?

Any success story will be appreciated.

Regards,

Alex