HYPERTHREADING on older P4???
Quoted 6 lines · Dave Jones
There are countless rumours of being able to enable extra siblings by poking MSRs, but not one person has to my knowledge achieved this. Some folks have also allegedly found that snipping pins or wiring extra bits to them have enabled the 'extra sibling'. Whether this is true or not, and whether it is 100% equivalent to a real HT part is again, questionable.
HT-capable P4s decide at RESET (or INIT?) time whether to enable the second thread or not by sampling one of the data or address pins. The chipset is supposed to drive that pin low or high according to how HT has been set up in the BIOS. This is mentioned in the 3.06 GHz P4 data sheet.
/Mikael
Quoted 4 lines · Dave Jones
It means there is one 'thread'. Ergo, you do not have the possibility of running this as you would a true HT P4. There are a limited number of Northwood P4's out there which do support HT and have >1 sibling, but asides from those, you'll need a Xeon to take advantage of it.
The 3.06G parts are pretty available, but the prices are just getting silly. I suppose it will drop when the supply of parts exceeds the demand of people who can't wait.
Quoted 6 lines
There are countless rumours of being able to enable extra siblings by poking MSRs, but not one person has to my knowledge achieved this. Some folks have also allegedly found that snipping pins or wiring extra bits to them have enabled the 'extra sibling'. Whether this is true or not, and whether it is 100% equivalent to a real HT part is again, questionable.
There is one "fix" going around which supposedly works using the firmware upgrade capability. I have no idea if it does or even could work, I never had the guts to try it, because I'm not sure that changes really go away on power cycle, and I didn't get it from a trusted source. The idea of untrusted code running in the firmware is scarier than booting Windows.
Quoted 5 lines · Mikael Pettersson
HT-capable P4s decide at RESET (or INIT?) time whether to enable the second thread or not by sampling one of the data or address pins. The chipset is supposed to drive that pin low or high according to how HT has been set up in the BIOS. This is mentioned in the 3.06 GHz P4 data sheet.
This is my understanding, and it makes the idea of a firmware fix sound more possible, by just enabling the 2nd sibling if HT capability exists. I'll still let wonone else check it out first...
Signature · 3 lines
bill davidsen <[email protected]> CTO, TMR Associates, Inc Doing interesting things with little computers since 1979.