Skip to contentSkip to conversation

usb keyboard stuck?

DISCUSSION Benjamin LaHaise 1 participant 1 message Feb 24, 2003

lore
Share & tools
lore
#0 lore raw

Hello folks,

I've just had an odd occurance with a USB keyboard setup where the shift / alt / control keys became stuck. The only way to get sane control of the system back was to unplug the usb keyboard and plug it back in. Note that upon plugging it back in, the system logged a few unknown scancode messages, which seems a bit odd. Any ideas if this is the fault of the keyboard or the driver? Info on any experiences might be helpful, especially if someone else is using a Logitech iTouch keyboard. Cheers,

-bben
--
Junk email? <a href=mailto:"[email protected]"> [email protected] </a>

application bug: xterm(9022) has SIGCHLD set to SIG_IGN but calls wait(). (see the NOTES section of 'man 2 wait'). Workaround activated. usb.c: USB disconnect on device 02:06.1-2.1.2 address 4
usb.c: USB disconnect on device 02:06.1-2.1.2.1 address 6 usb.c: USB disconnect on device 02:06.1-2.1.2.3 address 7 hub.c: new USB device 02:06.1-2.1.2, assigned address 8
hub.c: USB hub found
hub.c: 3 ports detected
hub.c: new USB device 02:06.1-2.1.2.1, assigned address 9
input0: USB HID v1.10 Keyboard [LOGITECH USB Keyboard] on usb3:9.0
input1: USB HID v1.10 Pointer [LOGITECH USB Keyboard] on usb3:9.1 hub.c: new USB device 02:06.1-2.1.2.3, assigned address 10
input2: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on usb3:10.0
keyboard: unknown scancode e0 3a
keyboard: unknown scancode e0 1e
keyboard: unknown scancode e0 1e
keyboard: unknown scancode e0 0e
keyboard: unknown scancode e0 2e
keyboard: unknown scancode e0 2e
keyboard: unknown scancode e0 0e
keyboard: unknown scancode e0 0e
keyboard: unknown scancode e0 13
keyboard: unknown scancode e0 33
keyboard: unknown scancode e0 33
keyboard: unknown scancode e0 23