Skip to contentSkip to conversation

kbuild: Smart notation for non-verbose output

PATCH In review Sam Ravnborg 2 participants 2 messages Mar 3, 2003 Kbuild

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 kbuild: Smart notation for non-verbose output

Hi Kai.

Create a nice shorthand to enable the non-verbose output mode.
make V=1 => Gives verbose output (default)
make V=0 => Gives non-verbose output

One of the reasons why people does not use KBUILD_VERBOSE=0 that much is simply the typing needed.
This notation should make it acceptable to type it.
The usage of "make V=0" is restricted to the command line. Anyone that wants to enable the non-verbose mode pr. default shall set KBUILD_VERBOSE in the shell.

Sam

===== Makefile 1.391 vs edited =====

Makefile +5 -0
@@ -107,6 +107,11 @@
 
 #	For now, leave verbose as default
 
+ifdef V
+  ifeq ("$(origin V)", "command line")
+    KBUILD_VERBOSE = $(V)
+  endif
+endif
 ifndef KBUILD_VERBOSE
   KBUILD_VERBOSE = 1
 endif
#1 lore raw

On Mon, 3 Mar 2003 22:51:12 +0100
Sam Ravnborg <[email protected]> wrote:

| Hi Kai.
| 
| Create a nice shorthand to enable the non-verbose output mode.
| make V=1	=> Gives verbose output (default)
| make V=0	=> Gives non-verbose output
| 
| One of the reasons why people does not use KBUILD_VERBOSE=0 that
| much is simply the typing needed.
| This notation should make it acceptable to type it.
| The usage of "make V=0" is restricted to the command line.
| Anyone that wants to enable the non-verbose mode pr. default shall
| set KBUILD_VERBOSE in the shell.

Nice. Thank you.

--
~Randy