New module: kernel recompile?
make menuconfig - check there the right module
and then
make modules && make modules_install
I did it a few times and it went ok
HTH,
petre
On Wednesday 02 April 2003 17:43 Anno Domini, Amin wrote using one of his
keyboards:
Quoted 16 lines
Hi, I've installed a new RH8.0 system after losing the old one. Problem is, the fresh installation doesn't support my (Myson) Ethernet card, and I have to load the ``fealnx'' module to get it to do so. And that module isn't already compiled and insertable. So: is it possible to compile the module and then insert it into the kernel, instead of recompiling the whole kernel, as I had to do the last time? (Not that I don't like recompiling the kernel; it just gets a little boring during the 5 hours it takes.)
I've got the ``.config'' file from my previous RH8.0 installation (on the same system) and can put it up for anyone who's interested.
Thanks,
Yawar
Quoted 5 lines
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs
--
10:56PM up 5:52, 2 users, load averages: 0.36, 0.31, 0.22
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs