Skip to contentSkip to conversation

I can't use aic79xx with RAID

DISCUSSION Marco De Benedetto 3 participants 3 messages Apr 18, 2003 – Apr 19, 2003 SCSI

lore
Share & tools
lore
#0 lore raw

I have a NEC Express 2800 with Adaptec AIC-7902 U320 and two disks.

I have compiled the kernel 2.4.20 with the 2.4.21-pre7 patch and the support for aic79xx, now I can see the two disks but after creating the RAID(0/1) the kernel does not see any disk. I have also tried the latest drivers from Justin T. Gibbs.

Is it supposed that aic79xx should work with RAID?

BTW, does someone know what are the performance of the Linux sw RAID1 with respect to hw RAID1?

Signature · 2 lines
thank you,
Marco De Benedetto
#1 lore raw
Quoted 1 line

Is it supposed that aic79xx should work with RAID?

The HostRAID feature is not currently supported for Linux.

--
Justin

#2 lore raw
In reply to Marco De Benedetto
Quoted 4 lines · Marco De Benedetto

I have compiled the kernel 2.4.20 with the 2.4.21-pre7 patch and the support for aic79xx, now I can see the two disks but after creating the RAID(0/1) the kernel does not see any disk. I have also tried the latest drivers from Justin T. Gibbs.

Software raid is independant of the underlying driver so that bit should just work.

Quoted 2 lines

BTW, does someone know what are the performance of the Linux sw RAID1 with respect to hw RAID1?

CPU wise its basically zero overhead. The PCI bus overhead kills you at high performance rates so its a tradeoff. On the other hand most but not all hardware raid cards have crappy on board controllers, firmware that is funny, non free managemet tools and low power CPU's that mean they still underperform software raid in most respects.