Problems in kernel 2.4.70-mm9 with pcmcia xircom_cb
A message that is not in the archive (sent off-list or not yet received): [email protected]
Hi:
Thanks ....... again, my pcmcia card bus xircom_cb working good.
Regards.
---------- Original Message -----------
From: Dominik Brodowski <[email protected]>
To: [email protected], [email protected]
Sent: Fri, 13 Jun 2003 20:33:20 +0200
Subject: Re: Problems in kernel 2.4.70-mm9 with pcmcia xircom_cb
Quoted 4 lines
Hi "jds",
Please run "oldconfig" on your .config, and select
Quoted 8 lines
CONFIG_YENTACardBus yenta-compatible bridge support (NEW) "y"(Or run any other config tool of your choice and adjust this setting).
If
CONFIG_YENTAwasn't set before, this is likely the cause of the problem. If not, please contact me again.Dominik
------- End of Original Message -------