Skip to contentSkip to conversation

cdrom blocksize reset bug with 2.4.x kernels

PATCH Attila Kinali 3 participants 4 messages Jul 1, 2003 – Nov 12, 2003 Uniform cdrom driver

lore
Share & tools
lore
#0 lore raw

Hi,

After some discussion on the mplayer-users mailinglist about that for some scsi drives it's impossible to read a data cd after reading a vcd/scvd until the next reboot.
(see http://mplayerhq.hu/pipermail/mplayer-users/2002-December/025696.html)

I found that there is a reset of the cdrom block size needed for those drives which doesnt restet it themselfs if a new cd is put in (looks like only a few scsi cdroms are affected)

Attached is a small patch for drivers/cdrom/cdrom.c that fixes this for the 2.4.20 kernel (and also for 2.4.21 as the code didn't change). It's reseting the blocksize when a cdrom is opened for the first time (meaning that a umount/mount cycle can reset the blocksize).

I run this code now for about half a year and didnt have any problems. But, as i didnt get any feadback from other people, i'm not sure if everything is correct.

Greetings
Attila Kinali

Signature · 4 lines
Emacs ist für mich kein Editor. Für mich ist das genau das gleiche, als wenn
ich nach einem Fahrrad (für die Sonntagbrötchen) frage und einen pangalaktischen
Raumkreuzer mit 10 km Gesamtlänge bekomme. Ich weiß nicht, was ich damit soll.
		-- Frank Klemm, de.comp.os.unix.discussion
cdrom.c renamed from cdrom.c.orig +9 -1
@@ -475,7 +475,15 @@
 	else
 		ret = open_for_data(cdi);
 
-	if (!ret) cdi->use_count++;
+	if (!ret)
+	{
+		cdi->use_count++;
+		if(cdi->use_count == 1)
+		{
+			/* reset blocksize in case it's wrong */
+			cdrom_switch_blocksize(cdi,CD_FRAMESIZE);
+		}
+	}
 
 	cdinfo(CD_OPEN, "Use count for \"/dev/%s\" now %d\n", cdi->name, cdi->use_count);
 	/* Do this on open.  Don't wait for mount, because they might
#1 lore raw
Quoted 17 lines · Attila Kinali

Hi,

After some discussion on the mplayer-users mailinglist about that for some scsi drives it's impossible to read a data cd after reading a vcd/scvd until the next reboot.
(see http://mplayerhq.hu/pipermail/mplayer-users/2002-December/025696.html)

I found that there is a reset of the cdrom block size needed for those drives which doesnt restet it themselfs if a new cd is put in (looks like only a few scsi cdroms are affected)

Attached is a small patch for drivers/cdrom/cdrom.c that fixes this for the 2.4.20 kernel (and also for 2.4.21 as the code didn't change). It's reseting the blocksize when a cdrom is opened for the first time (meaning that a umount/mount cycle can reset the blocksize).

Quoted 3 lines

I run this code now for about half a year and didnt have any problems. But, as i didnt get any feadback from other people, i'm not sure if everything is correct.

If you clean this up wrt coding style, it can go in.

Signature · 1 line
Jens Axboe
#2 lore raw

As it seems Attila did not write a follow up, I had a look at his patch and the problem. The following patch fixes it for me (Plextor PX-32TS).

Please CC me on replies, I am not subscribed to the list.

include/linux/cdrom.h +2 -1
@@ -743,7 +743,8 @@
     	char name[20];                  /* name of the device type */
 /* per-device flags */
         __u8 sanyo_slot		: 2;	/* Sanyo 3 CD changer support */
-        __u8 reserved		: 6;	/* not used yet */
+        __u8 use_read10	: 1;		/* Use READ10 instead of READCD */
+        __u8 reserved		: 5;	/* not used yet */
 	struct cdrom_write_settings write;
 };
 
drivers/cdrom/cdrom.c +35 -16

89 lines not on this page · raw message

Signature · 1 line
Tobias						PGP: http://9ac7e0bc.2ya.com
#3 lore raw

No comments on this?

Quoted 117 lines · I wrote:

As it seems Attila did not write a follow up, I had a look at his patch and the problem. The following patch fixes it for me (Plextor PX-32TS).

Please CC me on replies, I am not subscribed to the list.

include/linux/cdrom.h +2 -1
@@ -743,7 +743,8 @@
     	char name[20];                  /* name of the device type */
 /* per-device flags */
         __u8 sanyo_slot		: 2;	/* Sanyo 3 CD changer support */
-        __u8 reserved		: 6;	/* not used yet */
+        __u8 use_read10	: 1;		/* Use READ10 instead of READCD */
+        __u8 reserved		: 5;	/* not used yet */
 	struct cdrom_write_settings write;
 };
 
drivers/cdrom/cdrom.c +35 -16
@@ -1400,6 +1400,8 @@
 	return 0;
 }
 
+static int cdrom_switch_blocksize(struct cdrom_device_info *cdi, int size);
+
 /*
  * Specific READ_10 interface
  */
@@ -1408,6 +1410,7 @@
 			 int blocksize, int nblocks)
 {
 	struct cdrom_device_ops *cdo = cdi->ops;
+	int ret = 0;
 
 	memset(&cgc->cmd, 0, sizeof(cgc->cmd));
 	cgc->cmd[0] = GPCMD_READ_10;
@@ -1419,7 +1422,22 @@
 	cgc->cmd[7] = (nblocks >>  8) & 0xff;
 	cgc->cmd[8] = nblocks & 0xff;
 	cgc->buflen = blocksize * nblocks;
-	return cdo->generic_packet(cdi, cgc);
+
+	if (blocksize != CD_FRAMESIZE) {
+		ret = cdrom_switch_blocksize(cdi, blocksize);
+		ret |= cdo->generic_packet(cdi, cgc);
+		ret |= cdrom_switch_blocksize(cdi, CD_FRAMESIZE);
+	} else ret = cdo->generic_packet(cdi, cgc);
+
+	/*
+	 * Switch cdrom_read_block back to default behaviour
+	 * if we get an error.
+	 * FIXME: Maybe this should not be done on all errors.
+	 */
+	if (ret != 0)
+		cdi->use_read10 = 0;
+
+	return ret;
 }
 
 /* very generic interface for reading the various types of blocks */
@@ -1428,8 +1446,15 @@
 			    int lba, int nblocks, int format, int blksize)
 {
 	struct cdrom_device_ops *cdo = cdi->ops;
+	int ret;
+
+	if (cdi->use_read10)
+		return cdrom_read_cd(cdi, cgc, lba, blksize, nblocks);
 
 	memset(&cgc->cmd, 0, sizeof(cgc->cmd));
+	/*
+	 * SCSI-II devices are not required to support READ_CD.
+	 */
 	cgc->cmd[0] = GPCMD_READ_CD;
 	/* expected sector size - cdda,mode1,etc. */
 	cgc->cmd[1] = format << 2;
@@ -1452,7 +1477,15 @@
 	default			: cgc->cmd[9] = 0x10;
 	}
 
-	return cdo->generic_packet(cdi, cgc);
+	ret = cdo->generic_packet(cdi, cgc);
+	if (ret && cgc->sense && cgc->sense->sense_key==0x05 && cgc->sense->asc==0x20 && cgc->sense->ascq==0x00) {
+		ret = cdrom_read_cd(cdi, cgc, lba, blksize, nblocks);
+		if (ret == 0) {
+			cdi->use_read10 = 1;
+			printk(KERN_INFO "cdrom.c: drive does not like READ_CD for blksize=%d, switching to READ_10.\n", blksize);
+		}
+	}
+	return ret;
 }
 
 /* Just about every imaginable ioctl is supported in the Uniform layer
@@ -1956,20 +1989,6 @@
 		cgc.sense = &sense;
 		cgc.data_direction = CGC_DATA_READ;
 		ret = cdrom_read_block(cdi, &cgc, lba, 1, format, blocksize);
-		if (ret && sense.sense_key==0x05 && sense.asc==0x20 && sense.ascq==0x00) {
-			/*
-			 * SCSI-II devices are not required to support
-			 * READ_CD, so let's try switching block size
-			 */
-			/* FIXME: switch back again... */
-			if ((ret = cdrom_switch_blocksize(cdi, blocksize))) {
-				kfree(cgc.buffer);
-				return ret;
-			}
-			cgc.sense = NULL;
-			ret = cdrom_read_cd(cdi, &cgc, lba, blocksize, 1);
-			ret |= cdrom_switch_blocksize(cdi, blocksize);
-		}
 		if (!ret && copy_to_user((char *)arg, cgc.buffer, blocksize))
 			ret = -EFAULT;
 		kfree(cgc.buffer);
Signature · 2 lines
-- 
Tobias						PGP: http://9ac7e0bc.2ya.com
Signature · 3 lines
Tobias						PGP: http://9ac7e0bc.2ya.com
This mail is made of 100% recycled bits.
np: ROUND TABLE featuring Nino: Let Me With You 03 - AudioTrack 03 []