2 2.6.0-test1 issues
Didn't see anything relevant in the Changes file or a grep through Documentation dir.
I can SSH out of my 2.6.0-test1 box (IPv4 and IPv6). When I try to ssh in though I get a prompt for a passphrase like normal but once I enter it nothing happens it just hangs there.
On bootup I get multiple FATAL messages about tty and ttyS. They're scattered throughout the startup process and don't seem tied to any particular init scripts.
Robert
:wq!
---------------------------------------------------------------------------
Robert L. Harris | GPG Key ID: E344DA3B
@ x-hkp://pgp.mit.edu
DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.
Diagnosis: witzelsucht
IPv6 = [email protected] http://ipv6.rdlg.net
IPv4 = [email protected] http://www.rdlg.net
Quoted 7 lines · Robert L. Harris
I can SSH out of my 2.6.0-test1 box (IPv4 and IPv6). When I try to ssh in though I get a prompt for a passphrase like normal but once I enter it nothing happens it just hangs there.
On bootup I get multiple FATAL messages about tty and ttyS. They're scattered throughout the startup process and don't seem tied to any particular init scripts.
Make sure you have a line in /etc/fstab for /dev/pts, like the following:
none /dev/pts devpts defaults 0 0
My recollection is that I've seen this happen with at least some 2.4 kernels as well, so it's not a 2.6-specific thing. I may not be remembering correctly, however.
Also note that some distributions will go ahead and mount /dev/pts without having a line for it in /etc/fstab, so this isn't needed for all Linux boxes.
-Barry K. Nathan <[email protected]>
GAH, I should have know that one and yes it fixed both problems as well as a new one with ETerms failing to start in X.
Thanks alot,
Robert
Thus spake Barry K. Nathan ([email protected]):
Quoted 24 lines · Robert L. Harris
Quoted 7 lines
I can SSH out of my 2.6.0-test1 box (IPv4 and IPv6). When I try to ssh in though I get a prompt for a passphrase like normal but once I enter it nothing happens it just hangs there.
On bootup I get multiple FATAL messages about tty and ttyS. They're scattered throughout the startup process and don't seem tied to any particular init scripts.
Make sure you have a line in
/etc/fstabfor/dev/pts, like the following:none
/dev/ptsdevpts defaults 0 0My recollection is that I've seen this happen with at least some 2.4 kernels as well, so it's not a 2.6-specific thing. I may not be remembering correctly, however.
Also note that some distributions will go ahead and mount
/dev/ptswithout having a line for it in/etc/fstab, so this isn't needed for all Linux boxes.(quoted diff) +0
-2-Barry K. Nathan <[email protected]> -
Quoted 4 lines
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
:wq!
---------------------------------------------------------------------------
Robert L. Harris | GPG Key ID: E344DA3B
@ x-hkp://pgp.mit.edu
DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.
Diagnosis: witzelsucht
IPv6 = [email protected] http://ipv6.rdlg.net
IPv4 = [email protected] http://www.rdlg.net