Skip to contentSkip to conversation

Power Management Update

DISCUSSION Éric Brunet 1 participant 1 message Sep 1, 2003

lore
Share & tools
lore
#0 lore raw

To: [email protected],[email protected]
Subject: Re: Power Management Update

(Resend. Seems it didn't get through the first time.)

Quoted 5 lines · you

I'm pleased to announce the release of the first patchset of power management changes for 2.6.0. The purpose of this release is to give people a chance to review and test the PM code before it's sent on to Linus.

I gave this patch a try... All data concerning my computer (config files, boot messages, dsdt, etc.) is available on
<http://perso.nerim.net/~tudia/bug-reports>.

On my computer, echoing anything to /sys/power/state does nothing at all. Not even a line in the logs.

On the text console (but with XFree and kde running in the background),

echo 1 > /proc/acpi/sleep

the screen blinks and the fan speed goes up. (fan speed is set by bios. Loading module i2c reinitialize the motherboard sensors and make fan speed go up too. But here, i2c was not loaded nor compiled in.) In the logs, I have:

Stopping tasks: ==================================================|
hdc: start_power_step(step: 0)
hdc: completing PM request, suspend
hda: start_power_step(step: 0)
hda: start_power_step(step: 1)
hda: complete_power_step(step: 1, stat: 50, err: 0)
hda: completing PM request, suspend
hwsleep-0257 [16] acpi_enter_sleep_state: Entering sleep state [S1]
Back to C!
PM: Finishing up.
PCI: Setting latency timer of device 0000:00:1d.0 to 64
PCI: Setting latency timer of device 0000:00:1d.1 to 64
PCI: Setting latency timer of device 0000:00:1d.2 to 64
PCI: Setting latency timer of device 0000:00:1f.5 to 64
eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
hda: Wakeup request inited, waiting for !BSY...
hda: start_power_step(step: 1000)
blk: queue df60d800, I/O limit 4095Mb (mask 0xffffffff)
hda: completing PM request, resume
hdc: Wakeup request inited, waiting for !BSY...
hdc: start_power_step(step: 1000)
hdc: completing PM request, resume
Restarting tasks... done

Note that, sometimes, the computer waits after printing "Entering sleep state [S1]", and resumes if I hit the key. The screen is however fully lit, so I am not sure that this is a success.

echo 3 > /proc/acpi/sleep

Maybe the screen blinks a little bit, but I am not sure. It is so fast... In the logs, I have:

PM: Preparing system for suspend
Stopping tasks:
=========================================================| Restarting tasks... done

echo 4 > /proc/acpi/sleep

Suspend is working, the computer writes things in the swapfile and shuts down. On resume, I have a kernel panic. I have hand written this:

Process swapper
Call queue:

        start_request
        ide_do_request
        __elv_do_drive_cmd
        generic_ide_suspend
        autoremove_wake_function
        printk
        suspend_device
        device_suspend
        prepare
        pm_resume
        do_initcalls
        init_workqueues
        init
        init
        kernel_thread_helper
Code: Bad EIP value
Kernel panic: Attemppted to kill init

Regards,

Éric Brunet