2.6: CPU dependent inline in 8250 serial drivers
Hi Russell,
drivers/serial/8250.h in 2.6 contains the following:
<-- snip -->
...
#if defined(__i386__) && (defined(CONFIG_M386) || defined(CONFIG_M486)) #define SERIAL_INLINE
#endif
#ifdef SERIAL_INLINE
#define _INLINE_ inline
#else
#define _INLINE_
#endif
...
<-- snip -->
Why should these functions be inlined only for 386 and 486 CPUs but not for more recent CPUs or other architectures?
cu
Adrian
Signature · 4 lines
"Is there not promise of rain?" Ling Tan asked suddenly out
of the darkness. There had been need of rain for many days.
"Only a promise," Lao Er said.
Pearl S. Buck - Dragon SeedQuoted 16 lines · Adrian Bunk
drivers/serial/8250.hin 2.6 contains the following:<-- snip -->
...
#ifdefined(__i386__)&& (defined(CONFIG_M386)||defined(CONFIG_M486)) #defineSERIAL_INLINE
#endif#ifdef
SERIAL_INLINE
#define _INLINE_ inline
#else
#define _INLINE_
#endif
...
Quoted 4 lines
<-- snip -->
Why should these functions be inlined only for 386 and 486 CPUs but not for more recent CPUs or other architectures?
The old serial.c did that as well - its mainly there so we don't go overboard and inline stuff when it isn't necessary. From what I remember when this was discussed some time ago, 386 and 486 performs better when they have the interrupt handling as one function, but other CPUs perform better when the code is out of line.
Since people tend to care about getting good performance from their serial ports, I preserved this trick.
Signature · 2 lines
Russell King ([email protected]) The developer of ARM Linux http://www.arm.linux.org.uk/personal/aboutme.html