Skip to contentSkip to conversation

Local APIC with ACPI freezes ASUS M2400N

DISCUSSION Robert Vollmert 1 participant 2 messages Sep 22, 2003 – Sep 24, 2003

lore
Share & tools
lore
#0 lore raw

Hello,

when Local APIC is enabled, my ASUS M2400N notebook (Centrino / ICH4-M chipset) freezes when ACPI initialises or tries to switch the display device. When Local APIC is not enabled, this does not occur. This happens both with 2.4.22 with ACPI patch from 20030916 and with unpatched (apart from a patch to load the DSDT via initrd) 2.6.0-test5.

On 2.4.22, it is possible to avoid the freeze during boot-up by disabling the vga console. I haven't tested this on 2.6.0-test5.

The freeze occurs when the DSDT writes to SystemIO address 0xb2. It does this both to query information about the active display device and to change the device.

I haven't been able to determine which of these writes exactly causes the freeze. When booting successfully by modifying the DSDT to bypass initialisation of the VGA device, it was possible to read the display status successfully a few times before a read caused the system to freeze.

If there's some more information you need, please let me know.

Cheers
Robert

#1 lore raw

Re: Local APIC with ACPI freezes ASUS M2400N (update)

Hello,

Quoted 6 lines

when Local APIC is enabled, my ASUS M2400N notebook (Centrino / ICH4-M chipset) freezes when ACPI initialises or tries to switch the display device. When Local APIC is not enabled, this does not occur. This happens both with 2.4.22 with ACPI patch from 20030916 and with unpatched (apart from a patch to load the DSDT via initrd) 2.6.0-test5.

[...]

Quoted 3 lines

The freeze occurs when the DSDT writes to SystemIO address 0xb2. It does this both to query information about the active display device and to change the device.

a little more information on this issue: The XFree86 driver for the chipset (i855GM) has some code for switching and querying active displays that talks to the video BIOS via "int 10h".

Adapting this to LRMI (http://sourceforge.net/projects/lrmi), it is possible to query and set the active display devices. This works without freezing the computer even when "Local APIC" is enabled.

Is it likely or at least possible that the BIOS talks to the video BIOS when the DSDT writes to 0xB2? If so, is that something it shouldn't be doing, or should this not cause any problems?

Cheers
Robert