mpc8245
Hi all,
I am working on mpc8245 based board. I have compiled the ppcboot with 64MB ram and its working fine and linux is ported successfully.
But when I have configured the RAM to 182MB in ppcboot, I am getting the boot prompt and while loading linux its crashing . What can be the reason?
Thanks & Regards,
Rakesh
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 5 lines · In message <[email protected]> you wrote:
I am working on mpc8245 based board. I have compiled the ppcboot with 64MB ram and its working fine and linux is ported successfully.
But when I have configured the RAM to 182MB in ppcboot, I am getting the boot prompt and while loading linux its crashing . What can be the reason?
Your RAM initialization sequence is broken.
Also, 182 MB of RAM is a _very_ strange size.
Also, PPCBoot is a dead project. You shouls not use it for current work. You should rather switch to U-Boot instead.
And finally, all this is off toopic on this list, and you should rather post to U-Boot-Users.
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected]
"A witty saying proves nothing." - Voltaire
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/