Skip to contentSkip to conversation

VIA IDE performance under 2.6.0-test7/8? (and test9)

DISCUSSION Claas Langbehn 1 participant 1 message Nov 2, 2003

lore
Share & tools
lore
#0 lore raw

Hi,

If I cat /proc/ide/via it shows that my harddisc is only using 88,8 MB/s, but it is an U100-disc. hdparm show that its using udma5, is this all correct, or should /proc/ide/via show 99,9 MB/s ?

----------VIA BusMastering IDE Configuration----------------

Driver Version:                     3.38
South Bridge:                       VIA vt8235
Revision:                           ISA 0x0 IDE 0x6
Highest DMA rate:                   UDMA133
BM-DMA base:                        0xdc00
PCI clock:                          33.3MHz
Master Read  Cycle IRDY:            0ws
Master Write Cycle IRDY:            0ws
BM IDE Status Register Read Retry:  yes
Max DRDY Pulse Width:               No limit
-----------------------Primary IDE-------Secondary IDE------
Read DMA FIFO flush:          yes                 yes
End Sector FIFO flush:         no                  no
Prefetch Buffer:              yes                 yes
Post Write Buffer:            yes                 yes
Enabled:                      yes                 yes
Simplex only:                  no                  no
Cable Type:                   80w                 80w
-------------------drive0----drive1----drive2----drive3-----
Transfer Mode:       UDMA       PIO      UDMA       PIO
Address Setup:      120ns     120ns     120ns     120ns
Cmd Active:          90ns      90ns      90ns      90ns
Cmd Recovery:        30ns      30ns      30ns      30ns
Data Active:         90ns     330ns      90ns     330ns
Data Recovery:       30ns     270ns      30ns     270ns
Cycle Time:          22ns     600ns      60ns     600ns
Transfer Rate:   88.8MB/s   3.3MB/s  33.3MB/s   3.3MB/s
# hdparm -i /dev/hda

/dev/hda:

Model=ST3120023A, FwRev=3.33, SerialNo=3KA1ERGQ
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% } RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4 BuffType=unknown, BuffSize=2048kB, MaxMultSect=16, MultSect=16 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=234441648 IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120} PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 AdvancedPM=no WriteCache=enabled
Drive conforms to: ATA/ATAPI-6 T13 1410D revision 2:

* signifies the current active mode

Regards, claas