Skip to contentSkip to conversation

Bug during media scan, kernel 2.4.23-pre9

DISCUSSION Stephan von Krawczynski 1 participant 1 message Nov 3, 2003

lore
Share & tools
lore
#0 lore raw

Hello,

I just encountered a real bad problem with using media scan on 3ware controllers. I have 3 hds connected and configured a RAID5. I use media scan regularly (daily basis). Since two days I see this problem:

Nov  3 18:12:11 box 3w-xxxx[2039]: INFORMATION: Verify started on unit 0 on
controller ID:2. (0x29)
Nov  3 18:19:41 box kernel: 3w-xxxx: scsi2: Unit #0: Command (f6e5d800) timed

out, resetting card.

After that the box has problems, the controller obviously hangs. This in itself can be considered a bug, but what is really annoying is that one has no chance finding out _which_ port caused the problem.
So at this point you can play roulette and replace one of the hds hoping that it was indeed the bad one.

It would be really a lot better to degrade the unit in this case and give a hint which port has problems (command timed out on port ...). This would:
a) not hang the box
b) give you a chance to replace the hd, as you would expect in RAID5

The current situation is absolutely _no good_.

Regards,
Stephan